Am29LV160D

说明：  系统中采用了电压反馈闭环，单片机通过内部软件产生一路SPWM控制信号，然后经过逻辑门变换电路变换成逆变全桥所需的四路驱动信号，再经专用驱动芯片TLP250隔离放大后，分别加到逆变全桥四个IGBT的栅极，进行驱动控制。(The voltage feedback closed loop is used in the system, and the single chip microcomputer generates all the SPWM control signal through the internal software, then transforms the four-way drive signal required by the logic gate transformation circuit into the inverter full bridge, and then adds to the gate of four IGBT of the inverter full bridge after the special drive chip TLP250 isolation and amplification, and carries on the drive control.)

Ventilation device in houme

It is a demo project for initializing GPIO, LED and USART by stm32f030f4p6 ARM microprocessor compiled by MDK Keil v5 and running on STM32F030 DEMO BOARD.

Conducted through virtual array DOA estimation, Rotating Machinery dimensional hologram of practical spectrum calculation routines, Synthetic Aperture Radar (SAR) imaging simulation target.

PIC19F946下的PWM测试程序，经过proteus测试能直接放在mplab下运行(PIC19F946 under PWM test procedure, after Proteus test can run directly on the MPLAB)

STM32微处理器三想正弦马安波输出测试原代码(STM32-SVPWM Waves OUTPUT)

通过STM32的USB实现对SD卡和内部Flash，Nandflash的读写(access to the internal flash,SD card,and Nand flash using stm32)

海德汉ENDAT2.2协议，CRC校验C代码，调试通过，绝对可用(CRC FOR endat2.2)

CC1110中断实验，简单明了的实现方法，使用IAR工程提供可以直接使用(err)

基于STM32F103的BLM100模块RFID UHF读卡程序。能将读到卡的ID号显示在LCD屏上。(RFID UHF reader program module based on the STM32F103 BLM100. You can read the card ID number displayed on the LCD screen.)