infrared-small-target-detect

矢量控制系统中的PI调节器，此为转矩调节器(PI regulator vector control system, this is the torque regulator)

对二维图片进行中心放大，能控制放大的倍数，采用最近邻法(enlarge pictures from the center of it，can control the index for enlargement)

MATLAB5.X入门与提高.pdf 想学习MATLAB编程的入门书籍，可以参考(Introduction and improvement of MATLAB5.X PDF want to learn MATLAB programming entry books, can refer to )

说明：  对常见的调制信号在软件无线电的通用平台下进行调制解调。所有信号均通过正交分解后，在一个同用的平台上进行调制，然后通过各自的解调算法解调。(right common modulation radio signals in the software under a common platform for modulation and demodulation. All signals are orthogonal decomposition, the same one used on the platform for modulation and demodulation through their respective demodulation algorithm.)

电弧仿真模型，delft大学，含有mayr、cassie等6种模型(Arc model, delft university， containing mayr, cassie six kinds of models)

基于cvca模型的标准卡尔曼程序及误差分析，适用于学生(The standard model based on Kalman cvca procedures and error analysis, applies to students)

非常有用的MATLAB与VisualC__NET混合编程介绍(MATLAB is very useful to introduce programming and mixed VisualC__NET)

selective harmonic elimination

BP神经网络代码，使用LM算法（高斯牛顿法的改进，具有很好的鲁棒性）(BP neural network code, use the LM algorithm (modified Gauss-Newton method has good robustness))

编写M文件，创建如下图形窗口，分别绘制如下图所示的曲线。 （1）曲线y=sin(t)sin(9t)，要求采用红色，点线。横坐标取值范围[0~ ]，标注x轴、y轴并加标题。 （2）一组余弦曲线，其振幅分别为0.4，0.6和0.8。横坐标取值范围[0~2 ]。添加图例与标题。进入图形编辑状态，调整图例的位置。 （3）分别绘制peaks函数的曲面图和网格线图。对曲面图做平滑处理，并添加标题与colorbar。 (Write M file, create the following graphics window, curves were plotted as shown below. (A) the curve y = sin (t) sin (9t), require the use of a red dotted line. The abscissa in the range [0 ~  ], labeled x-axis, y-axis and a title. (2) a set of a cosine curve, and the amplitude was 0.4, 0.6, 0.8. Abscissa value range [0 ~ 2  ]. Add a legend and title. Into the graphical editing mode, adjust the position of the legend. (3) were drawn surface chart peaks function and grid line graph. Surface charts do for smoothing and add titles and colorbar.)