Network-Formation

基于RBF神经网络的三电机同步调速系统 控制 (Three-motor Synchronous Speed-regulation System Based on RBF Neural Network Control)

stm32F427的程序，此程序是利用STM32F427开发板的智能机器人的控制。包括对机器人的底盘的控制和云台的控制。(Stm32F427 program, this program is the use of STM32F427 development board intelligent robot control. Including the control of the chassis of the robot and the control of the pan/tilt.)

lpc2000 启动代码 说明，对编写boot代码，或者研究对应的平台很有用哦(Initialization code lpc2000)

单片机与FPGA的串口通信 单片机与FPGA的串口通信(MCU and FPGA-MCU and FPGA serial communication Serial communication)

CAN数据通信测试软件，用于实现CAN总线通信数据的收发和分析(CAN data communication test software for CAN bus transceiver and communication data analysis)

LED显示屏的二次开发，案例例子,有实时显示屏更新数据，动态文本效果。(LED display of the two development, the case, there are real-time display update data, dynamic text effect.)

Realtime clock and motor controler 16f877A

MPC08卡的高级测试程序，能够对MPC08卡的大多数功能进行测试。(MPC08 card advanced testing procedures, capable of MPC08 card most of the features to be tested.)

EEPROM读写实例，可直接写到STC12C5616AD烧写板子上的C程序(Instance can be directly read and write EEPROM programming board wrote STC12C5616AD C program)

单片机上电以后LCD屏上显示欢迎回家， 先验证指纹再验证密码 ，同时验证成功开锁 指纹和密码分别可以验证3次 3次都错蜂鸣器响 ，按下manage键进入管理员模式 可以修改密码 删减指纹，指纹用开关量表示(After the microcontroller is powered on, the LCD screen shows welcome home. First verify the fingerprint and then verify the password. At the same time, verify the successful unlocking fingerprint and password can verify that the buzzer rings three times and three times respectively. Press the management key to enter the administrator mode to modify the password and delete the fingerprint. The fingerprint is expressed by the switch.)