CRC-SEAQ

说明：  该程序给出了利用Saleh模型进行功率放大器预失真的过程．(The program gives the power amplifier pre-distortion with Saleh models.)

针对数字卫星常用的 7 种通信信号调制方式(QPSK、8PSK、16QAM、32QAM、64QAM、16APSK、32APSK)，对零中心归一化瞬时幅度谱密度最大值、四次方谱、幅度、高阶累积量四种特征参数进行了分析，提出了一种联合特征参数的信号调制识别方法．(Aiming at seven communication signal modulation modes commonly used in digital satellite (QPSK, 8PSK, 16QAM, 32QAM, 64QAM, 16APSK and 32APSK), four characteristic parameters of zero-center normalized instantaneous amplitude spectral density, quadratic spectrum, amplitude and high-order cumulant are analyzed, and a signal modulation recognition method of joint characteristic parameters is proposed. Method.)

it is a discription of starbucks supplychain managment system

种基于VB6．0开发的可进行瓦斯监测并报警的友好界面。该界面通过串行通信方式接收各种瓦斯报警器采集的数据。(Species can be developed based on VB6.0 gas monitoring and alarm-friendly interface. The serial communication interface to receive a variety of gas alarm, the data collected.)

电力最常用的规约的学习资料，包括101,102,103,104，modbus，cdt，其中104还有测试程序，及解析工具；( The most commonly used power statute learning materials, including 101,102,103,104, modbus, cdt, where there are 104 test procedures, and analysis tool )

uC OS_II在DSP芯片TMS320F281x上的移植(OS_II embedded DSP chip in the transplant TMS320F281x)

说明：  idunno wat am i doing

说明：  横河CS3000培训讲义 DCS经典介绍和操作(Yokogawa CS3000 classical training, introduction and operation of DCS notes)

NFC协议第一部分，描述了NFC tag 1 通讯协议(NFC protocol first part describes the communication protocol NFC tag 1)

this file talk about network