demo_files

2路18B20采集程序，读取两路温度，两路温度同时利用单总线原理读取内部温度并显示在1602上(2-way 18B20 acquisition program that reads two temperature, two temperature while using the principle of a single bus read the internal temperature and display in 1602)

first come first serve

数字温度显示器源代码，用于显示DS18B20传感器传送过来的数据。(The digital temperature display source code for display the DS18B20 sensor data sent over.)

中航信ETERM放大器，C++ 支持350，443端口，分享一下，一起学习(CNAC letter ETERM amplifiers, C++ 350,443-port, share, learn together)

说明：  ESP8266 PWM控制一盏LED的亮度变化。(ESP8266 PWM controls the brightness change of an LED.)

ESP8266 PWM控制一盏LED的亮度变化。(ESP8266 PWM controls the brightness change of an LED.)

MXL90614 红外温度传感器的驱动程序，测量精度在0.2度之内。(the drive program for MXL90614 temperature sensor 。)

dsp28335中文datasheet 其中包括epwm ecap ecan gpio pll配置信息(datasheet of 28335 contain epwm ecap ecan gpio pll )

说明：  用UART做文件传输_采用Zmodem协议,单片机程序.(To do with the UART using Zmodem protocol file transfer _, SCM)

这是一个为数不多的用C语言编写的PIC12C508的RGB灯的小型控制器，交流同步信号检测，七彩跳变+七彩渐变，做LED的朋友可以参考，程序可以直接使用的；(This is a small controller RGB lights a few written by C PIC12C508, AC synchronous signal detection, colorful jump+ colorful gradient, do LED friends can reference, the program can be used directly )