ThreadSample

使用奇异值分解算法的prony算法用于电机故障诊断(SVD algorithm prony algorithm for the motor fault diagnosis)

有关 C语言的CRC校验的资料，很实用，值得收藏和学习(About the C language, the CRC data, it is practical, it is worth collecting and learning)

这是一个为数不多的用C语言编写的PIC12C508的RGB灯的小型控制器，交流同步信号检测，七彩跳变+七彩渐变，做LED的朋友可以参考，程序可以直接使用的；(This is a small controller RGB lights a few written by C PIC12C508, AC synchronous signal detection, colorful jump+ colorful gradient, do LED friends can reference, the program can be used directly )

基于单片机的可燃气体报警器，反应灵敏，报警及时(Based on the single-chip microcomputer combustible gas alarm, sensitive, timely alarm.)

STC15单片机驱动LCD12864，并且是使用串口通信协议，节约IO口，亲测可用(STC15 microcontroller driven LCD12864, and you are using serial communication protocol, save IO ports, pro-test available)

STM32单片机freemodbus的移植，主从机的都有(1, transplant FreeModbus1.5 and RT-Thread1.1.1 to STM322, development platform supports Eclipse, Keil, IAR3, can be used in the Eclipse plug-in version management EGIT 4, support Modbus RTU (ASCII untested))

基于MSP430G2553 TI超低功耗单片机，5110液晶显示程序(Based MSP430G2553 TI ultra-low power microcontroller, 5110 LCD procedures)

IEEE14节点模型，PSCAD案例，同步发电机功率60MW，电压等级230kV(IEEE14 node model, PSCAD case, synchronous generator power 60MW, the voltage level of 230kV)

用于MMC桥臂计算，特别适用于较为复杂的MMC平衡子模块电容电压的计算(MMC is used to calculate the arm, especially for more complex calculations MMC submodule capacitor voltage balance)

串口发送数据，字符，12864接受并显示字符(Serial port to send data, the character, to accept and display the character 12864)