div7

基于m16的温度控制系统，主要用ds18b20(failed to translate)

峰值电流控制的BOOST,DC-DC电路，48V转80V，具有ZCS环境(Peak current control BOOST, DC-DC circuit, 48V switch 80V, with ZCS environment)

这是用asm编写的IOA口使用程序，是用16位的凌阳单片机汇编(This is asm2 prepared by the IOA I use the program is the use of Sunplus 16 MCU Series)

说明：  熟悉pic控制12864 LCD的使用方法 LCD循环显示本站网址和电话 硬件要求：LCD直接与单片机的A口和D口相连接所有拨码开关置OFF (Familiar with the pic to control the use of 12864 LCD cycle LCD display site URL and phone hardware: LCD directly with the MCU and D I A I connected all the allocated code switch OFF Purchase)

CCS3.3的中文入门手册，介绍CCS环境搭建流程，更有多核交叉编译的调试方法。(CCS3.3 of Chinese Primer introduces CCS environment to build process, more multi-core cross-compiler debugging methods.)

STC32的IIC存储芯片24C64操作 通过高度 程序稳定 (STC32 the IIC memory chip 24C64 operating procedures through a highly stable)

参考ti提供得例子程序，先将他们得例子在自己得板子上跑起来，其实就是用自测试得方式来验证一下程序，也可以加些中断，看看程序怎么跑得。这步没问题得话，可以改写程序，当然还在自测试模式下先试，如果可以改写后，在自测试模式下可以。那么就差不多了，将自测试模式改成正常模式，将程序移植到自己得程序中，拿一个经过验证可以正常通讯得can模块通讯，记得两个can得速率要一致。当然这个can模块还要能让你看到或者说能验证你得can是否通讯正常。(Reference ti provide examples of procedures was, first they have to run up on the example of the board that she has, in fact, self-test was used to verify the program mode, you can also add some interruption to see how to run the program. This step was not a problem, you can rewrite the program, of course, still in test mode since the first try, if you can rewrite, can in self-test mode. Well almost, the self-test mode to normal mode, the program was ported to own program, get a proven module can communicate normally too can communicate, remember that two can get a rate to be consistent. Of course, this can also allow you to see the module or can verify whether you have can communicate properly.)

基于PIC16F73的流星雨效果灯光控制 的 灯光数据接受(PIC)

基于MSP430F5438A的单相SPWM,产生，脉宽可调，波形完美，频率可调(MSP430F5438A-based single-phase SPWM, generation, pulse width adjustable waveform perfect, adjustable frequency)

nrf905模块的无线通信例子，希望有用(Nrf905 module wireless communication example, hope useful)