ChaosAttractors

直升机显模型跟踪控制系统仿真实例（MFCS）控制仿真，具有实用性的控制方法！(helicopter MFCS control system simulation。)

时域处理算法，本源码是关于时域预处理放面的内容，包含简易的算法(Time domain processing algorithms, the source is placed on the surface pretreatment time-domain content, including a simple algorithm)

最新的OFDM仿真以及相关算法的PDF文档，其中在知网下的(OFDM simulation and related algorithms PDF documents)

metlab code for different filters

中文版DLX流水线技术相关方面介绍以及简单应用 适用于面对初学者讲解(Chinese version of the DLX pipeline technology-related aspects of introduction and a simple application Suitable for beginners to explain face)

Application of rule d nearest neighbor to build the partition of the Vornoi

对瑞利信道进行仿真，得到清晰的瑞利分布。(For Rayleigh channel simulation, get a clear Rayleigh distribution.)

二元算术编码，即实现0和1 的算术编码，matlab源程序(Binary arithmetic coding, which implements the arithmetic coding 0 and 1, matlab source code)

bp神经网络的非线性系统建模————非线性函数拟合(nonlinear system modeling bp neural network nonlinear function fitting )

说明：  根据前人研究成果可以证明，煤镜质组反射率各向异性对煤田构造特征具有指示意义，镜质组最小反射率可以指示构造主应力方向。然而，在实际测量中，如何得到真正的镜质组最大、最小反射率及其方位是其中的关键环节。利用现有的岩石有限应变椭球拟合方法进行镜质组反射率椭球体拟合不失为一种行之有效的方法，可以由此确定镜质组最大、最小、中间反射率及其三维空间方位。 将之前拟合得到的反射率椭圆看作岩石有限应变椭圆即二维应变，其由之前的统计方法测定得到，三个截面的数据对于拟合唯一应变椭球来说是过多的，因此不可避免出现误差，导致三个截面应变椭圆不通过同一个椭球的情况。为了从三个截面数据得到唯一的应变椭球，需要对得到的数据进行相容性调整。采用Oertel的方法，从每一测量参数在不同截面中的值是正态分布这一假定出发，利用加权最小二乘法进行误差调整。(According to results of previous studies may prove vitrinite reflectance anisotropy on structural characteristics have implications for coal, vitrinite reflectance may indicate tectonic minimum principal stress directions. However, in actual measurement, how to get real vitrinite maximum, minimum reflectivity and its orientation is the key link. Conduct vitrinite reflectance ellipsoid fitting regarded as a proven method using existing rock finite strain ellipsoid fitting method can thus determine vitrinite maximum, minimum, intermediate reflectance and dimensional spatial orientation . Before fitting the reflectance of finite strain ellipse oval rock that is seen as a two-dimensional strain, as determined by statistical methods which have been before the data fit only for the three sections of the strain ellipsoid is excessive, and therefore can not to avoid errors, resulting in three elliptical cross-section does not pass through the same strain ellipsoid situation. In order to obtai)