IDCT_DCT

添加噪声处理，用于时频分析算法，实现六自由度运动学逆解算法。( Add noise processing, For time-frequency analysis algorithm, Six degrees of freedom to achieve inverse kinematics algorithm.)

基于状态观测器的二自由度汽车建模及控制分析，有动画直观显示(State observer based on two degrees of freedom and control of automotive modeling analysis has animated visual display)

数字预失真的LS算法，利用LS算法提取预失真参数(LS digital pre-distortion algorithm, using LS algorithm extracts the predistortion parameters)

说明：  基于声卡和MATLAB的语音信号采集和处理(MATLAB-based sound card and audio signal acquisition and processing)

使用meashift方法做的平滑和分割算法，用matlab写的(Meashift methods make use of the smoothing and segmentation algorithm, written using matlab)

利用数学形态学开闭设计滤波器消除漂移信号(Opening and closing design using mathematical morphology filter to eliminate signal drift)

HHT变换中用于边际谱与FFT比较的一个源码。本人亲试，出的图形基本满足要求。你可以下来看看。(HHT marginal spectrum for the transformation of a source compared with the FFT. I pro-test, the graphics basically meet the requirements. You can look down.)

论文分析了合成孔径雷达图像迭代滤波处理的效果及其问题，结合统计滤波方法和小波分析方法，提出了一种基于细节补偿的MAP迭代滤波算法。实验结果表明，新的迭代滤波算法较好地解决了去噪和细节保留之间的矛盾，而且算法稳定，收敛很快。(This paper analyzes the iterative synthetic aperture radar image filtering effect and its problems, combined with statistical filtering methods and wavelet analysis method, details of compensation, a MAP based iterative filtering algorithm. Experimental results show that the new iterative filtering algorithm can solve the denoising and detail preservation conflicts between, and the algorithm is stable and fast convergence.)

这是一个测试AQM参数的matlab 程序 主要用的是RED算法 呵呵 供大家看看(This is a test matlab program AQM parameter is mainly used for the RED algorithm Ha ha take a look at the)

The overall objective for LTE is to provide an extremely high performance radio-access technology that offers full vehicular speed mobility and that can readily coexist with HSPA and earlier networks. OFDM/OFDMA technology is introduced for the LTE downlink, supporting very high data rates of up to 300Mbps while Single-Carrier FDMA (SC-FDMA) is used in the uplink with data rates of 80Mbps possible. Additionally, LTE supports operation both in paired and unpaired spectrum (FDD and TDD) using channel bandwidths of approximately 1.4MHz up to 20MHz. The frequency domain scheduling can be done in OFDMA. One of the main challenges in OFDMA is the high peak-to-average radio of the transmitted signal, which requires linearity in the transmitter. The linear amplifiers have low efficiency therefore, OFDMA is not an optimized solution for a mobile uplink where the