-
tfrbj
计算Born-Jordon时间频率分布,需要输入的参数包括信号、时间、时间和频率的平滑窗口等参数(Born-Jordon calculating time-frequency distribution of the input signals ,including signals, time, time and frequency parameters of the smoothing window and so on .)
- 2013-11-26 19:35:19下载
- 积分:1
-
RadarSimulatingProgramme
This programme can generate signals of five different radars which contains noise.
- 2008-03-03 16:39:59下载
- 积分:1
-
rayleigh-chan
程序仿真了瑞利信道,分析和大量实测表明,多径效应使接收信号包络变化接近瑞利分布。在典型移动通信中,衰落深度达30dB左右,衰落速率约30~40次/秒。(Rayleigh channel simulation procedures, analysis and extensive test shows that the received signal multipath effect changes in the envelope close to the Rayleigh distribution. In a typical mobile communication, fading depth of about 30dB, the decline rate of about 30 to 40 times/sec.)
- 2013-09-21 00:25:14下载
- 积分:1
-
MATLABtutorial
简单实用的matlab教程 对初学者很实用(Simple and practical matlab tutorial is very useful for beginners)
- 2013-10-05 08:24:45下载
- 积分:1
-
newton
牛顿迭代法函数,有6个参数,可缺省后3个参数;动态画出迭代过程(Newton iteration function, there are 6 parameters, 3 parameters after the default dynamic iterative process to draw)
- 2011-05-26 22:11:40下载
- 积分:1
-
SlidingControToChaos
采用滑模控制对LORENZE混沌系统进行抑制(Sliding Control To Lorenze Chaos system)
- 2020-12-05 14:09:22下载
- 积分:1
-
shuangxianxin
用双线性法设计巴特沃斯低通滤波器,并用正弦信号验证。(Bilinear design Butterworth low-pass filter with a sinusoidal signal verification.)
- 2013-05-01 18:18:41下载
- 积分:1
-
MATLAB_2008a_install_guide
matlab2008a(7.6)破解说明及相关文件(matlab2008a (7.6) crack instructions and related documents)
- 2009-05-26 13:25:43下载
- 积分:1
-
LMS
说明: 用于计算最小均方误差的代码,包含了归一化的uniform函数(Used to calculate the minimum mean square error of the code, including the normalization of the uniform function)
- 2010-04-04 17:49:45下载
- 积分:1
-
Grid-Connected-PV-Array
Two demos illustrate use of SimPowerSystems for modeling a PV array connected to a utility grid.
PVarray_Grid_IncCondReg_det.mdl is a detailed model of a 100-kW array connected to a 25-kV grid via a DC-DC boost converter and a three-phase three-level Voltage Source Converter (VSC). Maximum Power Point Tracking (MPPT) is implemented in the boost converter by means of a Simulink model using the “Incremental Conductance + Integral Regulator” technique.
PVarray_Grid_PandO_avg.mdl is an average model of a 200-kW array connected to a 25-kV grid via two DC-DC boost converters and a single three-phase VSC. The MPPT controller based on the “Perturb and Observe” technique is implemented by means of a MATLAB Function block that generates embeddable C code.
- 2021-04-11 12:08:58下载
- 积分:1