basisfun

用鼠标画线，运行程序后，可以在axis界面上画任意曲线，且每个点的地址会返回到matlab主窗口(draw a line with a mouse)

　　编写一通用的预测法分析程序，要求有一定的错误处理能力，出错后能够使程序继续运行下去，直到分析过程结束。可通过不同的文法（通过数据表现）进行测试。(Write a generic prediction analysis procedure that requires a certain degree of error-handling capabilities, enabling the program to continue after an error to run it until the end of the analysis process. Can be tested by different grammar (by performance data).)

好不容易找到的matlab的时频分析工具箱，添加的方法不说了，里面的工具很全，挺好用的，希望对大家有帮助。(Finally found the time-frequency analysis matlab toolbox, adding that the method, which is full of tools, very good use, and would like to help everyone.)

It is an inverter six steps (indirect) (three phase)

基于ANSYS APDL二次开发的航电设备的动力学扫频分析，载荷输入条件为交越频率以下为恒定位移，交越频率以上为恒定加速度。我将加速度输入转换为位移输入，将位移和加速度两段输入载荷统一按照位移载荷输入，将位移存入表数组，利用ANSYS APDL自动将扫频范围内的位移载荷存入表数组，并循环加载计算，实现了该工程结构的正弦扫频振动分析。(Kinetic sweep analysis, load input conditions of secondary development based on ANSYS APDL avionics for the crossover frequency less constant displacement, above the crossover frequency is constant acceleration. I will convert the input displacement input acceleration, displacement and acceleration loads unity in accordance with the displacement of the two input load input, the displacement of the array into the table using ANSYS APDL automatically load displacement within the sweep range of the array into the table, and cyclic loading calculated to achieve a swept sine vibration of the project structure.)

说明：  MATLAB 常用命令集合。能够很好的帮助初学者进行指导。内用确实很丰富不容错过(MATLAB command set used. Can be a good guide to help beginners. With a very rich indeed not to be missed)

NC-OFDM系统的导频设计改进方法性能分析(Pilot design method of NC- OFDM system to improve performance analysis)

说明：  ofdm的同步方法的参考文献，讲述了各种不同的参考文献的方法。(The synchronization method ofdm references about a variety of different methods References.)

It describes the bitplane slicing method for detection of defect in a fabric. The defect is mostly detected in first two planes.

Regression test for 196109.