CalcCINR

这编程是关于三维图形的仿真，X.Y都是有取值范围的，图形都是有各种颜色(This program is about three-dimensional graphics simulation, XY are all the range, the graphics are a variety of colors)

双层规划模型的遗传算法求解的Matlab源码(GA for Bilevel Programming Model with Matlab)

增量式PID控制算法Matlab仿真程序 设一被控对象G（s）=50/(0.125s^2+7s),用增量式PID控制算法编写仿真程序（输入分别为单位阶跃、正弦信号，采样时间为1ms，控制器输出限幅：[-5,5],仿真曲线包括系统输出及误差曲线，并加上注释、图例）。(Incremental PID control algorithm Matlab simulation program to set up a controlled object G (s) = 50/(0.125s ^ 2+7s), with incremental PID control algorithm simulation program written (unit step input, respectively, sinusoidal signal sampling time is 1ms, the controller output limiter: [-5,5], including simulation system output and error curve curves, plus notes, legend).)

system identification base least square error on step peridiction

硕士论文用到的仿真程序，供大家参考 本文研究了基于磁链误差观测的控制方案，也就是采用SVPWM优化方案。将电压矢量脉宽调制技术和直接转矩技术相结合，利用磁链和转矩误差选择任意相位和幅值的电压空间矢量，从而减小了转矩脉动。(DTC, zero voltage vector, the stator flux linkage sectors subdivision, the asymmetry of flux increments asymmetry, SVPWM, torque ripple)

（1）在MATLAB环境下编写FFT算法（不调用系统现有函数）； （2）实现对选定图片进行FFT计算、还原（IFFT计算），并与系统FFT函数做对比，进行分析； （3）设计GUI界面。((1) the preparation of the FFT algorithm (do not call the system existing function) in MATLAB environment (2) to achieve the selected image to the FFT calculation, reduction (IFFT computing), and FFT functions to do comparison with the system for analysis (3) Design GUI interface.)

This is a matlab code to simulate PAPR Vs CCDF of Selective Mapping (SLM) based Peak-to-Average power reduction of OFDM signal.

在单目标无杂波环境下，针对二维雷达量测的目标跟踪算法的实例分析。包含了UKF与KF。(An example of a target tracking algorithm for two-dimensional radar measurement in a single target without clutter environment is presented. It contains UKF and KF.)

Demo script for testing for block-diagonalizability of real matrices

仿真多径瑞利衰落信道，仿真多径瑞利衰落信道，仿真多径瑞利衰落信道，仿真多径瑞利衰落信道(Simulation of multipath Rayleigh fading channel)