-AT89S51-with-ADC0809-

考虑磁场饱和效应的电励磁同步电机矢量控制的一篇论文，在电机考虑磁路饱和是挺有启发的(Electrically Excited Synchronous Motor Vector Control Considering Saturation Effect)

使用stm32f407单片机的CAN通信控制驱动电机，并且该程序可以通过红外遥控(CAN communication with stm32f407 MCU is used to control the driving motor, and the program can be controlled by infrared remote control.)

Minecraft启动模块 和例子 。。。。模块源码没有 不过挺好用的(Minecraft startup module and examples . . . . No source module But very good use)

说明：  stm32例程 用于学习目的 例程为stm32g系列 若其他系列需修改gpio引脚(STM32 routine is used for learning. The purpose routine is stm32g series. If other series need to modify GPIO pin)

xlinx公司关于xaui xgmii的讲解和产品介绍(xlinx company on xaui xgmii explanations and Products)

4通道ad7682驱动程序 在msp430单片机上调试成功(4-channel ad7682 driver debugging success msp430 microcontroller)

混合动力电动车用开关磁阻电机控制系统研究(博士论文)本文依托国家十五“863”电动汽车重大专题项目,对混合动力电动汽车用的开关磁阻电机(SR电机)控制系统的关键技术进行专题应用研究,研究成果在武汉市的混合动力电动公交车510线路上运行并取得了满意的效果(the behavior of the power cell restricts the application and development of electric vehicle)

stm32f4 adc 的代码，双通道，用DMA保存数据。(stm32f4 family c code, adc This example provides a short description of how to use the ADC peripheral to convert a regular channel in Dual interleaved mode using DMA in mode 3 with 5Msps. DMA mode 3 is used in interleaved mode in 6-bit and 8-bit resolutions. The Dual interleaved delay is configured 6 ADC clk cycles. On each DMA request (two data items are available) two bytes representing two ADC-converted data items are transferred as a half word. The data transfer order is similar to that of the DMA mode 2. A DMA request is generated each time 2 data items are available 1st request: ADC_CDR[15:0] = (ADC2_DR[7:0] << 8) | ADC1_DR[7:0] 2nd request: ADC_CDR[15:0] = (ADC2_DR[7:0] << 8) | ADC1_DR[7:0] The ADC1 and ADC2 are configured to convert ADC Channel 12, with conversion triggered by software. By this way, ADC channel 12 is converted each 6 cycles. In this example, the system clock is 168MHz, APB2 =84MHz and ADC clock = APB2 /2. Since ADCCLK=)

这是LM6029液晶显示的源程序和资料，程序调试过，可以用。(This is datasheet and C source of LCD LM6029,it can be used correctlly.)

光纤倏逝场传感器对甲醇 （CH3OH）和乙醇（C2H5OH）基于变形光学溶剂 纤维芯的报道。现有的U型的敏感性 探讨提高延长暴露芯线圈形状 一个半圈的形成，核心行进 三弯曲的形状。利用可见光的波长区域（VIS） 甲醇/乙醇从0 到10 所示的浓度 的弯曲形状的传感器使测定灵敏度 更好的甲醇浓度比0点05 和 乙醇的浓度比0 在650nm。这有利于 低成本的光源和接收器使用规定 这个波长范围以及聚合物的光的利用 纤维导光和从传感器，从而导致较低的 成本的应用相比，所有的二氧化硅或聚合物包层石英光纤 在近红外（NIR）解决方案或紫外线（UV）波长 范围。 (An optical fibre evanescent field sensor for methanol (CH3OH) and ethanol (C2H5OH) solvents based on deformed optical fibre cores is reported. The sensitivity of an existing U-bend probe is increased by extending the exposed core to a coil shape of one and a half turns and by forming the core to a meander shape with three bends. Using the visible wavelength area (VIS) and methanol/ethanol concentrations from 0 to 10 it is shown that the sensitivity of the meander shape sensor enables the determination of methanol concentrations of better than 0:5 and of ethanol concentrations of better than 0:2 at 650nm. This facilitates the use of low cost optical sources and receivers provided for this wavelength range as well as the utilization of polymer optical fibres to guide the light to and from the sensor which results in low cost applications compared to all silica or polymer clad silica fibre solutions in the near-infrared (NIR) or ultra-violet (UV) wavelength range.)