LDPC_QPSK

通过对非线性系统进行线性化，掌握状态反馈线性化方法的过程，并通过Simulink仿真过程，验证设计的控制率能否满足设计要求并进一步掌握状态反馈线性化方法(By linearization of nonlinear systems, state feedback linearization method to master the process, and by Simulink simulation verify the design of control rate can meet the design requirements and to further understand the state feedback linearization method)

说明：  书籍以及对应的例程，都可以使用 非常好用，而且每个章节也会有对应的模型，是有关于PMSM模型的，可以学习到 滑模控制、FOC控制以及弱磁等控制巴拉巴拉的(Books and corresponding routines can be used very easily. Moreover, there will be corresponding models in each chapter, which is about PMSM model. You can learn sliding mode control, FOC control and flux weakening control of Balabala)

优化问题的matlab解决方法，包括最优路径和动态规划、线性规划问题(optimization problems Matlab solutions, including optimal routing and dynamic programming, linear programming problem)

this document consists of the code to find the linear array radiation pattern

结构分析的有限元法与matlab程序设计5-1(Structural analysis of the finite element method and matlab programming 5-1)

Based on ECMA 2 Draft 7 February 1999.

QAM信号的生成程序（正交振幅调制，其幅度和相位同时变化）( QAM Signal generation Quadrature amplitude modulation, changes in the amplitude and phase at the same time)

It generates a 2dbreast phantom

Numerical Analysis Using MATLAB® and Excel®

function thah simulates a fading channel without gaussien nose