DSS_POWER

matlab book for bigenners very useful

说明：  简介卫星姿态控制系统的模型，并针对该模型分析故障发生的特点，故 障诊断的难点，以及可能发生故障的部位和故障的类型，给出故障检测的方法。(Introduction of satellite attitude control system model and the model for the analysis of the characteristics of faults, fault diagnosis of the difficulties, and possible failure location and fault type, fault detection methods are given.)

说明：  简易SSB设计 有详细的报告和说明，可以作为参考(Simple SSB detailed design reports and notes, can be used as reference)

电力系统PQ潮流计算 基于直角坐标 注意输入数据文档的格式(PQ power system power flow calculation based on a Cartesian coordinate attention to the format of input data files)

perform Jacobi method iterations

通信中的采样钟恢复，用gardner 算法提取时钟误差。(STR for sampling Time recovery)

设计音频降噪算法，并用MATLAB仿真实现。 1）读入一段音频后添加噪声，必须包括两种不同的噪声，信噪比：0dB~10dB； 2）分别采用滑动平均滤波器，直接频域滤波，以及谱分析后设计滤波器滤波三种方法实现，并对比效果。 3）给出各种方案的设计依据、代码、频响曲线，以及输入输出对比图。(Audio noise reduction algorithm design, and use MATLAB Simulation. 1) Read after adding noise into an audio, it must include two different kinds of noise, SNR: 0dB ~ 10dB 2) respectively moving average filter directly in the frequency domain filtering, and the filter is designed to achieve three methods filter after spectral analysis and contrast. 3) Give the design basis, code, frequency response curve, and input and output comparison chart of the various programs.)

说明：  通过simulink建立电磁阀模型，通过pwm控制，控制电磁阀的开闭(The model of solenoid valve is established by Simulink, and the opening and closing of solenoid valve are controlled by PWM control)

蒙特卡罗模拟实现蒙特卡罗模拟matlab实现用于结构可靠性分析(Monte Carlo simulation for Monte Carlo simulation matlab implementation for structural reliability analysis)

执行pesq的 pfile 文件, 需要用matlab 打开 但是只能用于执行 无法看原代码(p.file of running pesq in matlab )