danbihuan_zhuansufankuai

说明：  未编码传输AWGN信道测试 每帧的输入是相同的，（不是每帧都不一样，这样可以大幅降低计算量） 在帧比特足够多的情况下，应该可以保证随机性(AWGN channel is not coded transmission test input of each frame is the same, (not every frame is different, this can significantly reduce the computation) are enough bits in the frame of the case, should be able to guarantee randomness)

永磁直驱风力发电系统，含最大风力追踪，桨距角控制。简单模型(Permanent magnet direct drive wind power generation system, including maximum wind track, the pitch angle control. Simple Model)

一个很好的Matlab编制的数据降维处理软件(Matlab a good preparation of the data processing software Dimensionality Reduction)

nordig channel simulation

说明：  OFDM的接收和发射，是用Matlab编程实现的(OFDM receiver and launch, using the Matlab programming)

利用matlab求解混沌的各种类型，都有源程序，分的很细，很容易学习的(Use matlab to solve all types of chaos, there is source of very fine, very easy to learn)

机载SAR合成孔径雷达的地面运动目标的检测关键技术研究，包含硕士研究论文一篇(Research on key technologies to detect ground moving target airborne synthetic aperture radar SAR, including a master' s research paper)

说明：  负荷频率控制（LFC）是调整系统的频率达到额定值（如50HZ）或/和维持区域联络线交换功率为计划值。频率稳定是电力系统电能质量的一个重要指标。负荷的任意突然变化都有可能导致系统间联络线交换功率的偏差及系统频率的波动。因此，为保证电能质量，需要一个负荷频率控制(load frequency control,LFC)系统，该系统的目的是将系统频率维持在标称值并且尽可能使控制区域之间的未计划的联络线交换功率最小。(Load frequency control (LFC) is to adjust the frequency of the system to reach the rated value (such as 50 Hz) or / and maintain the exchange power of the regional tie line to the planned value. Frequency stability is an important index of power quality in power system. Any sudden change of load may lead to the deviation of power exchange between tie lines and the fluctuation of system frequency. Therefore, in order to ensure the power quality, a load frequency control (LFC) system is needed. The purpose of the system is to maintain the system frequency at the nominal value and minimize the unplanned tie line exchange power between the control areas.)

part1.m 1. Converts 14 image pairs of a video sequence to grayscale. 2. Computes the absolute difference between the pairs yielding 15 images. camshift.m 1. Implementation of the CAMSHIFT algorithm for tracking a hand in a video sequence. Executing this project from within Matlab At the command prompt enter: >>part1 >>camshift

高亮 Highcharts-4.0.3 Highcharts-4.0.3(high light)