UKF-design

Reciprocating compressor vibration signal spectrum analysis and fault diagnosis往复式压缩机振动信号频谱分析与故障诊断.pdf

本实验先利用Mathematica求解非线性方程(组),探索不动点的性质 再利用MATLAB探索Koch分形的性质.(In this study, the first use of Mathematica for solving nonlinear equations (group), to explore the nature of the fixed point re-use of MATLAB to explore the nature of the Koch fractal.)

Code for DWT WATERMARKing in an image

Mathematical modeling of DC Motor Model using current and speed equations

ＭＡＴＬＡＢ仿真Ｖ形振子的相关数据　电流　方向性图　(MATLAB simulation of V-shaped vibrator relevant data current directional map)

matlab源码关于模糊K均值聚类算法，适合大家下载研究学习(matlab source code on the fuzzy K-means clustering algorithm, suitable for everyone to download research study)

Simulating the dipole antenna by method of moments.

GPS c/a码功率估计计算例程，相互学习一下(GPS c/a code power the estimated calculation routines, learn about each other)

根据条形光波导折射率数据，分别针对宽高比a:b为1:1与 2:1两种情形，设计分析 ： 1. 满足单模与双模传输的 波导尺寸范围。（需要 给出色散曲线） 2. 针对两种情形，选取你 认为最佳的波导尺寸， 计算对应的模折射率。 （计算时假设上、下包 层均很厚）(According to the refractive index of the optical waveguide stripe of data, respectively, for an aspect ratio of a: b is 1: 1 and 2: 1 both cases, the design and analysis: 1. Meet single-mode and dual-mode transmission Bird size range. (need Given dispersion curve) 2. For both cases, you select That the best of the waveguide dimensions, Computes the corresponding mode refractive index. (Calculations assume that when the upper and lower package Layers are very thick))

implementation of the level set method in order to shrink an initial contour to a point, using Kappa and Kappa^(1/3).