equalizer-realtime

matlab仿真源程序，先进 PID 控制及其 MATLAB 仿真（程序）。(？？)

用matlab实现了简单遗传算法解决TSP问题，有界面。(Using matlab to achieve a simple genetic algorithm to solve the TSP problem, there are interfaces.)

光伏电池阵列输出功率受光照强度和温度变化的影响，因此最大功率点跟踪（MPPT）技术广泛应用于光伏系统中。在所有最大功率点(MPP)控制策略中，扰动观察（P&O）MPPT算法因易实现被广泛应用，然而它的缺点是在稳定工作状态下工作点通过MPP 时会导致能量振荡损耗，并且在光照强度或温度发生突变时表现较差的动态响应。在本文中，提出一种改进型变步长扰动观察MPPT 算法，此方法依据工作点动态调整步长变化，与传统固定步长方法比较，本文提出的方法能有效地提高MPPT 速度和转换效率，通过仿真和实验结果分析，验证了此改进算法的可行性。(PV array output power by light intensity and temperature changes, so the maximum power point tracking (MPPT) technology is widely used in photovoltaic systems. In all the maximum power point (MPP) control strategy, the perturbation and observation (P & O) MPPT algorithm because easy to implement is widely used, but its disadvantage is the steady-state operating point by the MPP causes energy oscillations loss, and in the light intensity or temperature mutated poor performance dynamic response. In this paper, we propose a modified variable step size perturbation and observation MPPT algorithm, this method is based on dynamically adjusting the operating point changes in steps, with the traditional fixed-step methods, the proposed method can effectively improve the speed and efficiency MPPT, The simulation and experimental results verify the feasibility of this algorithm.)

系统辨识中有色噪声和白色噪声的编程方法实现，基于matlab程序(The programming method of system identification in colored noise and white noise)

单载波频域均衡算法完整Matlab仿真程序(Single-carrier frequency domain equalization algorithm for a complete simulation program Matlab)

神经网络LMS算法(最速下降法),matlab源程序(neural networl LMS algorithm)

基于KPCA_SVM的柴油机状态识别方法的研究 把KPCA与SVM共同用到柴油机状态识别中(KPCA_SVM based on the state of the diesel engine study to identify methods of KPCA and SVM to identify the common use of diesel engine state)

求希尔伯特变换后的瞬时频率,经过信号的解析，反正切变换，求导得出(instant frequency)

MATLAB中用simulink搭建的完整的PCM通信系统模拟，可以完成PCM编码、解码的全过程(Complete PCM communication system simulation using MATLAB simulink structures can be completed PCM encoding and decoding of the entire process)

仿真2×1瑞利信道，分别考虑三种接收分集技术：最大比合并、等增益合并、选择性合并，并给出误码率比较。(In a one transmitting antenna and two receiving antenna collocate,calculate the bits error rates of the maximum ratio combining,equal gain combining ,selective combining and SISO system)