ThreePhase_ACDCAC_PMWconverter

SPWM model in simulink

template matching using corr2 function in matlab working very well

matlab中实现的G.726编码的算法及测试程序，在matlab中已经通过测试，并能输出编码结果(matlab code to implement the G.726 algorithm and testing procedures in matlab has been tested and the results can be output coding)

降低ofdm中峰均比的方法slm的matlab源码 (PAPR reduction method in ofdm slm of matlab source)

说明：  用于emd（经验模态分解）进行地震信号去噪(It is applied to emd (empirical mode decomposition) for seismic signal denoising)

matlab的有限元计算代码，可计算梁、桁架等结构(matlab，FEM)

说明：  bpsk仿真中间有两个方面的内容，很好的仿真软件(There are two files in the zip folder. bpsk_spread.m and jakesmodel.m Steps for simulation: 1] Run jakesmodel.m first 2] Then run bpsk_spread.m . 3] Note that during the first run bpsk_spread.m has no rayleigh fading.This is because the corresponding code has been commented 4] The resulting performance is stored in BER_awgn. 5] Now uncomment the Rayleigh Fading code in bpsk_spread.m file. 6] Same time comment BER_awgn (line 112) and uncomment BER_ray variable. 7] Run the simulation. )

说明：  语音信号的延时和混响设计 语音信号的延时和混响设计(signal delay )

说明：  关于码matlab的介绍，对于初学者来说能够很快了解matlab。(On the introduction of matlab code, for beginners to quickly understand the matlab.)

盲信号分离(BSS)指在源信号混合和传输信道未知的情况下，只利用接收天线的输出观测混合信号抽取源信号的方法。本文简要阐述了常用的瞬时混合盲信号分离的LMS与RLS自适应算法，对RLS自适应算法重点研究分析了基于普通梯度与自然梯度的两种算法，并通过仿真实验来分析比较几种方法的性能。(Blind signal separation (BSS) refers to the source signal and transmission channel mixing unknown circumstances, the only use of the receiving antenna output source signal observed mixed-signal extraction method. This paper describes commonly used blind source separation of instantaneous mixture of LMS and RLS adaptive algorithms, the RLS adaptive algorithm focuses on the analysis of general gradient and the natural gradient based on two algorithms, and through simulation experiments to compare several methods of analysis performance.)