-
GoldsequenceCDMAsimulation
写一个MATLAB程序,实现4个时间同步的CDMA用户的仿真,其中每个用户都使用长度为L=31的不同的Gold序列。每个用户都采用它们代表的Gold序列的二进制(+-1)调制。每个用户的接收端将这个复合的CDMA接收信号相关,而这个复合的信号都在它们各自的序列上受到AWGN的污损(基于按码片相加)。在N=10000信息比特下,仿真估值并画出作为SNR的函数的CDMA通信系统的差错概率。(Write a MATLAB program, the realization of the four time synchronization of the simulation of CDMA users, including the length of each user for use of the L = 31 different Gold sequences. They are used for each user on behalf of the Gold sequence of binary (+-1) modulation. Each user' s receiver will receive the composite CDMA signal, and this composite signal in the sequence of their respective defaced by the AWGN (additive based on the chip by). Information in the N = 10000 bits, the simulation value and draw as a function of SNR of the CDMA communication system the probability of error.)
- 2009-06-08 11:46:23下载
- 积分:1
-
Matalb_-various-command-set
matalb_各种命令集合(matlab使用中的各种命令的汇集,可以方便查找)(Matalb_ various command set)
- 2013-12-23 12:38:18下载
- 积分:1
-
ex01
说明: 此程序给出由三个不同频率的正弦所组成信号的联合时-频分布。该图是三维图形的二维投影,在该图中,一个轴是时间,一个轴是频率。由该图可清楚地看出信号的时间-频率关系。(This program shows three different frequency sinusoidal signal composed of joint time- frequency distribution. The plan is two-dimensional projection three-dimensional graphics in the figure, one axis is time, an axis is frequency. By the diagram is clear that the signal of the time- frequency relation.)
- 2011-03-21 15:11:29下载
- 积分:1
-
Puzzle
8-puzzle game with search strategy
- 2010-05-10 14:45:50下载
- 积分:1
-
qzsi-three-level
quisi three level inverter
- 2014-10-31 01:41:35下载
- 积分:1
-
float2qnm
MATLAB code for filter design for Qnm format
- 2009-02-10 19:23:33下载
- 积分:1
-
enframe
frame blocking, known as enframe or split the signal into specific frames.
- 2010-09-07 22:53:00下载
- 积分:1
-
household
说明: household变换,数值插值matlab源程序,插值算法,数值分析源码等。(household transformation, numerical interpolation matlab source, interpolation algorithms, numerical analysis of source code and so on.)
- 2011-02-21 16:15:09下载
- 积分:1
-
Chapter-6
elshebri source code5
- 2011-07-14 01:40:45下载
- 积分:1
-
m_files_1
This code is used to cut selected part of the image that is of course after you decompress.
And run the code in the image circle separated.
- 2014-08-13 21:59:48下载
- 积分:1