lab1

lms算法的自己编的程序 包括各种影响因素的分析等等 包括运行结果分析图(LMS Algorithm own procedures, including analysis of various factors including the results and so analysis)

IT gives a clear explanation of non-linear systems

The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):

关于mie散射的程序，可以求出mie散射中的各项参数。(Mie scattering program, you can find the parameters of the Mie scattering.)

说明：  用MATLAB/SImulink 搭建的单相光伏并网逆变器仿真，用PR电压环控制器进行控制，包含2012-2018所有版本(Simulation of single-phase photovoltaic grid connected inverter built by Matlab / Simulink, controlled by PR voltage loop controller, including all versions of 2012-2018)

Matlab经典算法__退火问题accessory_parameter (__ Annealing algorithm Matlab classic problem accessory_parameter)

matlab for compression

VC++与MATLAB混合编程研究及开发实例(VC++ and MATLAB)

单个化工过程CSTR反应器模型的非线性分岔图的作图程序。(A single CSTR reactor model of chemical process of nonlinear bifurcation diagram drawing program.)

matlab5 手册 教程 参考(Course reference manual matlab5)