Histogram

轨迹跟踪---船舶航迹控制，典型的欠驱动控制问题。两种算法，采用了matlab---simulink，直观明了。(Sailing ship trajectory tracking control, a typical under-actuated control. Two algorithms using matlab--- simulink, intuitive and clear.)

The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):

how to build a function in matlab

载波移相SPWM调制法是一种特别适合于级联多电平逆变器的SPWM方法,在matlab/simulink环境下下运行,这是本人搭建的一个小模型(Carrier phase shifting SPWM modulation method is a particularly suitable for cascaded multi-level inverter SPWM method, run in matlab/simulink environment under)

the basic code for mimo using 2x2 antenna

matlab求解两点边值问题的常微分方程组。追赶法求解。(chasing method for solving ODE bvps)

此程序为计算桁架受荷载作用下的位移及应力算例(This program is subject to displacement and stress calculation truss under load examples)

this is a maltab/sumulink simulation of &a novel adaptive neural control of nonlinear systems with actuator saturation,it simulates the algorithm proposed by slemic in 2004.

仿真数字波束形成(一维数字波束形成仿真和二维数字波束形成仿真)(Simulation of digital beamforming (one-two dimensional digital beamforming simulation))

赛车路线分析，解决这个问题时，我们主要是利用多次插值来求得曲线上的点，利用这些点来拟合比赛车道的曲线和选手的速度曲线，画出图像。用M语言并且用坐标平面上的点之间的距离计算公式计算周长L，用梯形法求所围区域的面积。最后根据速度图像来判断路况。(Racing line analysis)