4372873cell

image deionising using various filter in matlab

matlab code for emotion

一种下垂控制的模型，参数设好，可以运行，仅供参考学习。( One kind of droop control model, the parameters had set up, you can run it,just for reference study.)

GMM工具箱第一部分。包含了GMM算法的各个函数，对GMM建模很有帮助.(GMM first part of the toolbox. GMM algorithm contains all functions of GMM modeling helpful.)

matlab source code to perform jpeg compression using humfman coding

语音分离用的深度神经网络工具箱，matlab，非常全 (This folder contains Matlab programs for a toolbox for supervised speech separation using deep neural networks (DNNs).)

inverse updaing source code in matlab

针对OFDM系统，分成链路级仿真和系统级仿真两个部分。为了降低系统级仿真的复杂度，采用链路级仿真的部分结果。(It contains mainly two parts, i.e. link-level simulator and system-level simulator. Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx. Comparing the difference in tx/rx signal, the error rate can be found out. The output of the link-level simulator is the BLER/BER vs. SNR mapping table, that can be used for the system-level simulation. System-level simulator focus on a multi-cell multi-user scenario. For the sake of simplicity, it takes the mapping table aquired in the link-level simulation, measure the actural SNR, and finds the corresponding error rate. Link-level simulator support SISO, 1 by x MRC, 2 by 1 STBC/SFBC, 2 by 2 Alamouti, x by 1 Antenna selection, x by y antenna selection. System-level simulator, currently support only SISO and 1 by 2 MRC. To start with, go into the folder sys_link_simu, and excute the following commond from matlab: sys_link_simu_func(a,b) where a is the link ada)

二维光子晶体自聚焦光束的FDTD模拟程序 配PML吸收边界(Two-dimensional photonic crystal since the FDTD simulation program focused beam with PML absorbing boundary)

后续的接调制的程序，跟以前传的调制是在同样的环境下实现的(Follow-up modem access procedures, with the previous Chuan modulation is in the same environment to achieve)