LabVIEW_PID_Design_Source_Code

说明：  一个arm开发板的sd卡程序设计用于设计SD卡的实现(An arm development board designed sd card program is designed for the realization of SD card)

两份基于51单片机的交通灯，包括原理图，proteus仿真，PCB，实训报告等。是我单片机实训时的成品，调试成功的。(Based on 51 single two traffic lights, including schematics, proteus simulation, PCB, training reports. SCM training when I was finished, debugging success.)

stepper motor example with proteus

使用陀螺仪采集加速度、角速度、姿态角、温度、计步等数据，并上传到“匿名上位机”进行姿态显示。 本工程是移植自MPU6050官方驱动，包含了陀螺仪最完整的功能。(The use of gyro acquisition acceleration, angular velocity, attitude angle, temperature, and other data, and upload to the anonymous host computer attitude display. This project is a transplant the MPU6050 official driver, including the most complete function of the gyroscope.)

在实现流水灯闪烁在proteus8.6使用的单片机是STM32F103R6(realize led SCM STM32F103R6 is used in Proteus 8.6 to realize pipeline lamp flickering.)

STM32F103 MDK 工程，可以使用。。。。。。。。(STM32F103 MDK PROJECT)

用电脑串口控制单片机流水灯状态,用电脑串口控制单片机流水灯状态(Serial control with a computer chip light water status)

利用51单片机做的一个闹钟程序，可以自己设定闹铃时间(err)

说明：  RC522读取卡片UID,ATK-ESP8266 WIFI功能实现(RC522 reads card UID, ATK-ESP8266 WIFI function realization)

说明：  跳绳测试仪程序，基于STC单片机开发设计，精度高(Rope skipping tester program, based on STC microcontroller development design, high precision)