FromDigtoPWL

利用MATLAB编写的atrous算法程序,可适用于图像的多级小波分解(Prepared by the use of MATLAB algorithms Atrous procedures could be applied to image multi-level wavelet decomposition)

仿真了相控阵雷达的天线方向图，能进行不同的状态参数设置，产生的天线方向图(Simulation of a phased array radar antenna pattern, can be a different state parameter settings, resulting antenna pattern)

pwm rectifier which work in open loop for traction systems.matlab simulink modal is aasigned with it.

该程序实现多特征红线报警算法，两个matlab文件，一个为函数，另一个为主函数，调用该函数文件；该程序将4路信号，每一路信号的特征量值及其固定阈值求出来，并一起画出图来。(The program features multi-red alarm algorithm, two matlab files, one for function, the other main function calls the function file the program seek out four signals characteristics of each road and fixed threshold value ,then draw them out .)

trust region method optiomizatiom method

matlab仿真用的32采样点,GMSK调制解调代码(matlab simulation using the 32 sampling points, GMSK modem code)

simple fuzzy rule base

交流伺服系统中的死区效应分析与补偿分析了逆变器的死区效应产生的原因及其对交流伺服系统控制性能产生的影响,指出死区补偿的关键 在于电流相位的获取,为了克服实际系统中电流零点的模糊性,提出了一种基于两相静止坐标系下的前馈死 区补偿方法. 该方法通过对三相输出电流一个周期内补偿电压进行傅里叶变换,发现仅需补偿1 ,5 ,7 次谐波 分量即可消除死区效应. 仿真和试验结果验证了这种方法的正确性和可行性.(AC servo system analysis and compensation of dead time effect of the inverter dead time effect causes the impact of the control performance of the AC servo system, and pointed out that the dead time compensation, the key lies in the current phase of the acquisition, in order to overcome the practical zero of the current ambiguity of the system is proposed based on the two-phase stationary coordinate system under the feedforward dead-time compensation method. by the offset voltage of the three-phase output current cycle Fourier transform is found only compensation 1, 5, 7 harmonic components to eliminate the dead time effect. simulation and experimental results verify the correctness and feasibility of this approach.)

This is aadf demo page which contain some examples

在这个压缩文件中，你能看到用两种方法仿真机器人动作的例子。(In this file you can find an example that simulated a robot with using two soft wares.)