main_7Colors

基于DSP28335的PWM整流器程序设计，三相A、B、C静止坐标系下的控制(The PWM rectifier that is based on the three A B C static axes,which is controled by DSP28335)

STM32F103RBT6和W5200网络芯片的服务期端的测试程序，减少了很多不必要的设置，测试更方便(W5200 STM32F103RBT6 and end of service network chip testing procedures, to reduce a lot of unnecessary settings, the test is more convenient)

我是北京小米科技有限公司高级研发工程师，精通JAVA开发技术，主要负责网站、APP、软件开发，具有五年的JAVA开发工作经验。希望在CodeForge结识更多JAVA高手来学习、合作。(I am a senior R&D engineer of Beijing Millet Technology Co., Ltd. I am proficient in JAVA development technology. I am mainly responsible for website, APP, software development. I have five years experience in JAVA development. I hope to meet more JAVA experts in CodeForge to learn and cooperate.)

ra8806历程，51控制，测试可以使用 驱动液晶240*128液晶(ra8806 course, 51 control, test drive you can use the LCD 240* 128 LCD)

12864上面的并行画线，可以画圆，三角形，正方形，直线，正弦波(12,864 above the parallel line drawing, you can draw a circle, triangle, square, line, sine wave)

基于avr单片机atmega8的8位跑马灯源码(the source of atmega8 s led)

用单片机的汇编语言设计一个温度计，温差在一度以内(MCU assembly language to design a thermometer, the temperature difference was less than)

使用树莓派驱动ADXL345 显示欧拉角/OPENGL 3D建模控制 历史曲线等(Use raspberry pie to drive ADXL345 to display Euler angle/OPENGL 3D modeling control history curve, etc.)

编制MCS-51程序使步进电机按照规定的转速和方向进行旋转，并将已转动的步数显示在数码管上。 　　步进电机的转速分为两档，当按下S1开关时，加速旋转，速度从10转/分加速到60转/分。当松开开关时，减速旋转，速度恢复为10转/分。当按下S2开关时，按照逆时针旋转；当松开时，按照顺时针旋转。 　　本程序要求使用定时器中断来实现，不准使用程序延时的方式。(The MCS-51 program is programmed to rotate the stepper motor according to the specified speed and direction, and the number of steps that have been rotated is displayed on the digital tube. Stepper motor speed is divided into two gears. When the S1 switch is pressed, the speed is accelerated from 10 rpm to 60 rpm. When the switch is loosened, the speed will be reduced to 10 rpm. When pressing the S2 switch, rotate counterclockwise; when loosening, rotate clockwise. This procedure requires the use of timer interrupt to achieve, do not use the way of program delay.)

实现数码管0-7的静态显示，采用c语言编写。(play led)