FFTK

说明：  这是图论中常用的一些算法的matlab程序！适合建模呢！(This is a graph theory algorithm commonly used in some of the matlab program! Suitable for modeling it!)

1、系统仅处于训练状态。训练序列为2cos(2π×f1×n/fs)， 干扰为sin(2π×f2×n/fs)；序列长度为100个样点。 其中n=0…99，f1=1kHz，f2=2kHz，fs=8kHz。 2、采用LMS算法，均衡器输入为训练序列加上干扰，均衡器阶数为21阶，步长因子β=0.01。 3、在Matlab中编写浮点LMS算法，绘制均衡器的输出波形，并与训练序列进行对比。 (1, the system only in the training status. The training sequence is 2cos (2πf1n/fs), interference sin (2πf2n/fs) sequence length of 100 samples. Where n = 0 ... 99, f1 = 1kHz, f2 = 2kHz, fs = 8kHz. 2, using LMS algorithm, the input to the equalizer training sequence plus interference equalizer order is 21 bands, step factor β = 0.01. 3, the preparation of the floating-point LMS algorithm in Matlab, draw the output waveform equalizer, and with the training sequence comparison.)

the file is the algorithm used for the color based seganography with multiple compression algorithms

单模多项式矩阵的分解算法，支持符号运算，用matlab实现了smith算法(Polynomial matrix of single-mode decomposition algorithm, to support the symbolic operation, using matlab algorithm achieved smith)

交流BUCKBOOST拓扑的MATLAB仿真 (AC_BUCK_BOOST )

在分析自适应模糊控制及PID参数变化对系统性能影响的基础上,提出在动态过程中对PID参数进行整定.仿真研究表明,控制质量得到了提高.(In the analysis of adaptive fuzzy control and PID parameter changes on the basis of system performance, tuning the PID parameters in the dynamic process simulation studies have shown that quality control has been enhanced.)

用matlab gui画信号的频谱图和时域图形,再画出语谱图，模拟电话(Picture signal with matlab gui frequency spectrum and time domain graph, then draw the language spectrum, analog telephone)

codigo para detectar bordes

itti 1988的实验 ，显著性检测，很好的学习资料(itti 1988 experiment, a significant detection, good learning materials)

performance description for codes in LTE applications