doa_cs_ty_dj

可用于无协议串口调试和标准Modbus调试。例案：单片机无协议通信、变频器通信调试、PLC及工业仪表通信调试。(No agreement can be used for standard Modbus serial debugging and debugging. Example case: no agreement on single-chip communications, Converters debug communications, PLC and industrial instrumentation communication debugging.)

说明：  网络芯片ch563读写u盘例程，例程完整，方便开发(The network chip ch563 reads and writes the U disk routine, which is complete and convenient for development)

基于深度限幅的OFDM峰均比抑制器的设计（限幅法是最简单直接的一种，以降低误码率性能 频谱畸变和计算复杂度为主要代价。）(matlab OFDM)

Photovoltaic systems, solar thermal systems based on knowledge training(PVSystem)

在OPNET软件上实现路由层和MAC层协议的设计。路由层协议采取LEACH，MAC层协议包括TDMA和CSMA(Achieve routing layer and MAC layer protocols on OPNET software design. Routing layer protocols take LEACH, MAC layer protocols, including TDMA and CSMA)

用Visual C++的API函数来打开、关闭串口和设置串口通讯速率等功能。(Visual C++ using the API function to open and close the serial port and set up features such as serial communication rate.)

关于纠错码的很好的书籍。讲述了各种纠错码的原理(The error correcting code of good books. About the principle of a variety of error-correcting code)

基于MATLAB平台的通信系统的仿真，RS编码，OFDM调制，加入PLC信道噪声，并进行误码率的检测，运行无误，程序完整。(MATLAB-based communications system simulation platform, RS coding, OFDM modulation, adding PLC channel noise, and make BER testing, run correctly, the program integrity.)

高速DDR存储器数据接口设计实例. 1. 将文件拷入硬盘 2. 产生DQS模块 3. 产生DQ模块 4. 产生PLL模块 5. 拷贝以上步骤生成的文件到子目录【Project】中 6. 打开子目录【Project】中的DataPath.qpf工程，设计顶层模块 7. 编译并查看编译结果 (High-speed DDR memory interface design data. 1. Copyed into the document hard disk 2. DQS generated module 3. Have a DQ module 4. Have a PLL module 5. Copies of the above steps to generate a document to a subdirectory 【Project】 6. Open the subdirectory 【Project】 DataPath.qpf in engineering, design top-level module 7. compilers to compile the results and see)

一个基于串口的手机短信发送/接收程序；Demo很简单，是以异步方式读写串口的；在对话框初始化中修改串口的配置参数正确后，能100％的正常发送/接收短信。 (A message based on the serial port of the mobile phone to send/receive process Demo is very simple, based on asynchronous serial reading and writing in the dialog box to initialize the serial port to modify configuration parameters correct to 100 of the normal Send/receive message.)