Lucy-Richardson

传统的去噪算法在matlab环境下实现 (Traditional denoising algorithm to achieve the in matlab )

处理由采集卡采到的加速度传感器测得的信号，并分析其在0-1000Hz的频谱幅值并绘制频谱图(Processed by the acquisition card taken to the measured acceleration sensor signal, and to analyze the spectrum of the 0-1000Hz and draw the amplitude spectrum)

THI SM FILR CONVER FTROM ABC TO DQ0 IN ORDER TO DEMOSTRATE HOW TO USE THE MATLAB GUI AND SIMULINK

说明：  这是一个模拟多进程并发的MATLAb代码，能清楚的看到结果。在os可能会用到，对你可能有用。(This is a simulation of MATLAb code concurrent processes, can clearly see the results. In the OS might need, to you may be useful.)

光学非球面的模拟和计算，用于计算非球面的斜率(ASPHERE_DIFF calculates the slope of an aspherical surface at a given height)

利用4 PAM映射计算误码率 （caclulating BER with 4 PAM mapping, srrc pulse shaping）

在matlab环境下利用有限元分析方法，采用四面体单元计算单向拉伸杆的横截面应力(In the matlab environment using finite element analysis, calculated using one-way stretch rod tetrahedral unit cross-sectional stress)

一束5W 的线偏振光以Φ = 45 度方位角振动，垂直入射到玻璃 - 空气表面，该光束波长0.6μm，玻璃介质折射率1.54 @0.6m，当入射角θ从0-70 度变化时，通过给定条件，分别完成如下要求： 画出该光束反射光的光强曲线（I-θ）； 分析该反射光束的偏振态变化，画出偏振方向变化曲线（φ-θ）和偏振光束相位变化曲线 （Φ-θ）。 （注：光束从光密到光疏的界面，在入射角θ 从0-70 度变化中，包括了临界角θc）(Bunch of linearly polarized light 5W to Φ = 45 degrees azimuth vibration, normal incidence to the glass- air surface, the beam wavelength 0.6μm, glass refractive index 1.54 @ 0.6m, when the incident angle θ changes from 0-70 degrees By the given conditions, namely the completion of the following requirements: Draw the reflected light beam intensity curve (I-θ) analysis of changes in the polarization state of the reflected beam, draw the polarization direction of the curve (φ-θ) and polarized beam phase curve (Φ-θ). (Note: the light beam from the optical density of the interface is sparse, the incident angle θ  variation from 0-70, including the critical angle θc))

about saham predict with genetic algoritm and neural network. this program can prediction the flowing of saham.

目前常用的张正友的摄像机标定方法，对畸变系数增加了切向畸变，结果精度很高，可直接应用于程序中。(Zhang is currently commonly used in the Friends of the camera calibration method, the distortion coefficient increased tangential distortion, resulting in high accuracy can be directly applied to program.)