登录
首页 » Unix_Linux » MANUAL-JTAG-OPENBOX

MANUAL-JTAG-OPENBOX

于 2011-11-17 发布 文件大小:417KB
0 340
下载积分: 1 下载次数: 9

代码说明:

  doccument pdf sur le jtag du la openbox 800 avec shema et jkeys commandes

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • technology-Bluetooth-wireless
    关于蓝牙的设计 基于蓝牙技术的无线数据采集系统(The design is based on Bluetooth technology Bluetooth wireless data acquisition system)
    2011-06-23 20:48:51下载
    积分:1
  • 一种QPSK全数字化载波频偏估计算法
    信号利用QPSK调制,采用全数字化的频偏估计方法(A full digital frequency offset estimation method using QPSK modulation)
    2020-12-29 11:29:01下载
    积分:1
  • LTE-Ad
    分析仿真了LTE-Advanced系统部署Pico后的小区间干扰协调技术.本文针对在LTE—Advanced系统中部署Pico后恶劣的干扰条件进行了详细的分析,并重点讨论了三种可以有效兼容R8/R9终端的增强型ICIC技术。(Analysis and simulation of LTE-Advanced systems deploy Pico Inter-cell interference coordination techniques for LTE-Advanced systems deploy Pico bad interference conditions, carried out a detailed analysis, and focused on the three can be effectively compatible with R8/R9enhanced terminal ICIC technology.)
    2012-03-04 16:54:47下载
    积分:1
  • TheResearchAndIPDesignOfSMBusBasedSmartBattery
    本文研究了SMBus 规范,介绍了典型的基于片上系统(SoC)设计的知识产权核(IP)实现,采用自顶向下 (Top-down)的集成电路设计方法完成了设计,并架构了基于总线功能模型(BFM)的验证平台 完成功能仿真,顺利完成了逻辑综合和时序仿真。FPGA 验证和投片后测试均表明设计具有 良好的性能。(This paper studies the SMBus specification, based on the introduction of the typical system-on-chip (SoC) intellectual property core design (IP) implementation, using top-down (Top-down) of the integrated circuit design methods achieve a design and architecture based on the total Line functional model (BFM) achieve functional verification platform for simulation, successfully completed a logic synthesis and timing simulation. FPGA silicon validation and post-tests show that the design has good performance.)
    2009-03-26 12:16:53下载
    积分:1
  • BEIDOUWeixing
    北斗卫星接口文件 北斗卫星导航系统 空间信号接口控制文件 (测试版) (Beidou satellite interface file Beidou satellite navigation system space signal Interface Control Document (Beta))
    2012-11-04 12:16:07下载
    积分:1
  • 一种基于高阶累积量的数字调相信号识别方法
    说明:  对当前通信信号中常用的数字调相信号BPSK、QPSK、1/4一QPSK、8PSK的调制识别问题,提出了一种基于信号差分高阶累积量的识剐算法。该算法分两个层次进行调制识别,首先利用信号的四阶累积量特征对BPSK、QPSK和{1/4一QPSK、8PSK}信号进行识别,然后再利用信号差分的四阶和八阶累积量特征对1/4-QPSK、8PSK信号进行识别。从理论上分析了的该算法的有效性,并通过计算机仿真验证了算法具有良好的性能。(A recognition algorithm based on differential high-order cumulant is proposed for the modulation recognition problems of BPSK, QPSK, 1/4-QPSK and 8PSK, which are commonly used in current communication signals. The algorithm is divided into two levels for modulation recognition. Firstly, BPSK, QPSK and {1/4-QPSK, 8PSK} signals are identified by using the fourth-order cumulant characteristics of signals, and then 1/4-QPSK and 8PSK signals are identified by using the fourth-order cumulant and eighth-order cumulant characteristics of signal difference. The validity of the algorithm is analyzed theoretically, and the good performance of the algorithm is verified by computer simulation.)
    2020-06-21 09:40:02下载
    积分:1
  • DirectedDiffusion
    this describe the rouring protocol direct diffusion for wireless sensor network
    2010-02-09 14:38:45下载
    积分:1
  • Semilogy_Plot
    intelligent transportation system and internet of vehicles
    2020-06-24 21:40:01下载
    积分:1
  • A-New-Algorithm-for-DOA
    A New Algorithm for Joint Range-DOA-Frequency Estimation of Near-Field Sources
    2021-04-15 18:48:54下载
    积分:1
  • DPSK_PCM_TDM
    利用matlab simulink产生两路模拟语音信号,经过pcm编码、时分复用、DPSK调制经过同一个信道单向传输到对应的接收端。常用的三个模块 simulink、通信模块、信号处理模块。包括课程设计报告。(Using matlab simulink produce two analog voice signals through the pcm encoding, time division multiplexing, DPSK modulation over the same one-way transmission channel to a corresponding receiver. The three modules used simulink, communication module, a signal processing module. Including curriculum design report.)
    2021-03-22 20:39:16下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载