171007

c8051f060定时器0，系统时钟，交叉开关IO配置(C8051F060 timer 0, the system clock, switch IO configuration)

99秒马表，在Proteus设计两个数码管动态显示及一个键盘SP。在ucos下结合keil完成开始时，显示“00”，第1次按下SP后就开始计时。 第2次按SP后，计时停止。第3次按SP后，计时归零。 (99 seconds stopwatch, two in the Proteus design dynamic digital tube display and a keyboard SP. Keil in combination ucos completed under the beginning of the show " 00" , 1st timer after pressing the SP. 2nd by SP, the time to stop. The 3rd by the SP, the time zero.)

nrf24z1无线音频传输详细开发资料，PCB，原理图，源码。非常详细。(nrf24z1 wireless audio transmission detailed development information, PCB, schematics, source code. Very detailed.)

说明：  OLED驅動程序 (STM32 平台), 新版SPI 接口 OLED模块！ CS(片选，已接地，不用接) RET（复位）(OLED Driver (STM32 Platform))

51单片机的pid程序，设定上下限，控制pwm的输出。(51 MCU pid procedures set upper and lower limits, control pwm output.)

使用单片机实验板，在Keil C开发环境中编写串口发送和接收程序。在串口发送和接收程序中编程增加校验位，使用逻辑分析仪捕捉单片机串口引脚发送和接收数据的波形，并与串口接收和发送的数据进行比较。(Using SCM experiment board, in the Keil C development environment to write serial send and receive program. In the serial sending and receiving program, the program adds the parity bit, and uses logic analyzer to capture the waveform of the data sent and received by the serial port of the microcontroller, and compares it with the data received and sent by the serial port.)

该代码可以对电机运行实现 S型加减速运动,驱动步进电机(This code can realize S-type acceleration and deceleration motion for motor operation and drive stepper motor.)

傻瓜式lcd12864显示驱动程序，全部包含在12864.h文件中(Fool lcd12864 display drivers, all files contained in the 12864.h)

Fujitsu_Easy_Kit试用手记_从入门到精通(Fujitsu_Easy_Kit trial notes _ from entry to the master)

bluetooth module for proteus...........