Base-and-applition-of--MATLAB

这是一个用Matlab编写的用于WSN中质心算法计算节点位置的源程序(this resource is used to calculate the locationof the nodes in WSN)

杨氏双缝，光的干涉实验，matlab仿真，采用滑动块改变参数，可视化输出，GUI界面(Young s double-slit, optical interference experiments, matlab simulation, using the sliding block to change the parameters, visual output, GUI interface)

加入重复控制，bXYCZIo参数三相光伏逆变并网的仿真，代码里有很完整的注释和解释，基于互功率谱的时延估计，fUIRmUe条件给出接收信号眼图及系统仿真误码率，仿真图是速度、距离、幅度三维图像。( Join repetitive control, bXYCZIo parameter Three-phase photovoltaic inverter and network simulation, Code, there are very complete notes and explanations Based on the time delay estimation of power spectrum, fUIRmUe condition The received signal is given eye and BER simulation systems, FIG simulation speed, distance, amplitude three-dimensional image.)

8FSK的调制信号的产生、理论误码率及实际误码率统计分析(8FSK modulation signal s theoretical and actual BER analysis)

几个比较经典的算法，用来解决最短路径问题(to solve the min-distance problem)

此代码为三维菲涅耳全息图的再现代码，但是有部分错误还未完全研究明白(This code for the three Wei Feinie ears hologram reproduction code, but some of the error is not fully understood)

matlab 独立分量分析 fastica,icaplot,remmean,whiten，盲源分离,去均值,白化处理(matlab independent component analysis fastica, icaplot, remmean, whiten, blind source separation to the mean, whitening treatment)

simulink的仿真有两个阶段：一个为初始化，这个阶段主要是设置一些参数，像系统的输入输出个数、状态初值、采样时间等；第二个阶段就是运行阶段，这个 阶段里要进行计算输出、更新离散状态、计算连续状态等等，这个阶段需要反复运行，直至结束。(simulink simulation has two phases: one for initialization, this stage is mainly to set some parameters, such as the number of input and output system, initial state, the sampling time second stage is the operational phase, the Stages to calculate the output, update the discrete state, continuous calculation of the state, etc., this stage requires repeated runs to the end.)

说明：  fm调制和解调，matlab语言实现，可以改变fs，fc，ft(fm modulation and demodulation, matlab language, can change the fs, fc, ft)

matlab和C++混合编程，利用高斯算法计算Ax=B求解(Solve Ax=B Using combination matlab and c++)