lubang

IP113M circuit application

有相位跳变的单频信号，信号时域波形的刻画和FFT程序。注释完整，可读性高。(a single-frequency signal with phase jump and its FFT is described in this program and the explain is detailed, easy to read.)

MATLAB仿真永磁同步电机直接转矩控制，传统滞环+开关表控制，仿真效果很好(The direct torque control of permanent magnet synchronous motor is simulated by MATLAB, and the traditional hysteresis plus switching table control has a good simulation effect.)

This file is the matlab code related to the imaging.

利用matlab编制的利用单纯形处理工程问题的程序(compiled by the use of Matlab using simplex works, the procedure)

考虑了基站通过多个中继与多个用户的问题，基于背包问题提出了最优功率分配。(the optimal power allocation is presented based on knapsack problem for a system with a base station communication with multiple users assisted by multiple relay.)

麦克风语音增强,能偶达到语音增强的效果，通过滤波来实现语音增强(multiple microphone speech enhancement)

周期不大于127的扩频序列生成程序,可用于matlat的RAKE接收仿真.(Not more than 127 cycles of the spread spectrum sequence generation process, can be used for the RAKE receiver matlat simulation.)

二次规划点集配准，程序的执行效率很高，算法结果也不错(Quadratic programming point set registration, efficient)

产生升余弦滤波器的时域与频域波形，带有默认参数，滚降系数为alpha。(Time domain and frequency domain waveforms produce raised cosine filter with default parameters, roll-off factor for the Alpha.)