LMS

随机子空间的matlab主程序代码，可以实现高精度的信号辨识。按照《基于随机子空间和最小二乘法的介质损耗角测量方法》、常军博士论文《随机子空间方法在桥梁模态参数辨识中的应用研究》编写。(Stochastic subspace matlab main code, you can achieve high-precision recognition. Accordance with the " stochastic subspace-based least-squares method and dielectric loss angle measurement methods" , regular army doctoral thesis " stochastic subspace identification of modal parameters of the bridge in the applied research" to write.)

大型煤气炉的控制系统，稳定工作点在450度，无差控制，利用MATLAB中的simulink模块实现建模和模拟控制。(Large gas furnace control system, stable operating point at 450 degrees, no difference in control, using MATLAB simulink in the modeling and simulation of the control module.)

Mean Shift 这个概念最早是由Fukunaga等人[1]于1975年在一篇关于概率密度梯度函数的估计中提出来的,其最初含义正如其名,就是偏移的均值向量,在这里Mean Shift是一个名词,它指代的是一个向量,但随着Mean Shift理论的发展,Mean Shift的含义也发生了变化,如果我们说Mean Shift算法,一般是指一个迭代的步骤,即先算出当前点的偏移均值,移动该点到其偏移均值,然后以此为新的起始点,继续移动,直到满足一定的条件结束. 用matlab实现mean shift算法仿真(Mean Shift the concept was first used by Fukunaga et al [1] in 1975 in an article on the probability density function estimation of gradient raised its original meaning, as its name implies, is the offset of the mean vector, where is the Mean Shift a noun, it refers to a vector, but with the Mean Shift the development of the theory, Mean Shift the meaning has changed, if we say that Mean Shift algorithm, generally refers to an iterative steps, namely, first calculate the current point Mean offset, move the shift points to its average, and then as a new starting point and continue to move until the end to meet certain conditions. realize using mean shift algorithm matlab simulation)

method of moment to solve Current distribution of Dipole Antenna MOM方法解决天线电流分布问题(method of moment to solve Current distribution of Dipole AntennaMOM solution to the issue of antenna current distribution)

paper on A Novel Control Strategy for a Variable-Speed Wind Turbine With a Permanent-Magnet Synchronous Generator

关于物理层网络编码编码和模拟网络编码ANC的matlab仿真代码。里面有四个程序，希望对大家有用(Matlab simulation code on the physical layer network coding and network coding ANC simulation. There are four procedures, we hope to be useful)

matlab下的3电平VSC系统模型，对于初学者很有帮助，建议大家多多交流，互相帮助(The 3-level VSC system model under matlab is very helpful for beginners. It is recommended that you exchange more and help each other.)

LMS算法的修改更好地衔接和使用两个步骤尺寸较小的MSE(Modification of the LMS algorithm is better convergence and the use of two steps smaller MSE)

输入节点个数和路径权重可得到任意两点之间的最短路径，放在Muti_Cost矩阵中(Input node number and weight of available paths the shortest path between any two points, on Muti_Cost matrix)

segmenting image processing lazy snapping