mexcdf

calculation of load flow in power system using matlab power engineering field

此代码为《雷达系统分析与设计》的书中的代码(This code is " radar system analysis and design," the code book)

说明：  对肌电信号计算积分肌电值+均方根值+中值频率+平均功率频率(Computation of Integral EMG+RMS+Median Frequency+Average Power Frequency for EMG Signals)

adaptive time frequency analysis toolkit

说明：  根据前人研究成果可以证明，煤镜质组反射率各向异性对煤田构造特征具有指示意义，镜质组最小反射率可以指示构造主应力方向。然而，在实际测量中，如何得到真正的镜质组最大、最小反射率及其方位是其中的关键环节。利用现有的岩石有限应变椭球拟合方法进行镜质组反射率椭球体拟合不失为一种行之有效的方法，可以由此确定镜质组最大、最小、中间反射率及其三维空间方位。 将之前拟合得到的反射率椭圆看作岩石有限应变椭圆即二维应变，其由之前的统计方法测定得到，三个截面的数据对于拟合唯一应变椭球来说是过多的，因此不可避免出现误差，导致三个截面应变椭圆不通过同一个椭球的情况。为了从三个截面数据得到唯一的应变椭球，需要对得到的数据进行相容性调整。采用Oertel的方法，从每一测量参数在不同截面中的值是正态分布这一假定出发，利用加权最小二乘法进行误差调整。(According to results of previous studies may prove vitrinite reflectance anisotropy on structural characteristics have implications for coal, vitrinite reflectance may indicate tectonic minimum principal stress directions. However, in actual measurement, how to get real vitrinite maximum, minimum reflectivity and its orientation is the key link. Conduct vitrinite reflectance ellipsoid fitting regarded as a proven method using existing rock finite strain ellipsoid fitting method can thus determine vitrinite maximum, minimum, intermediate reflectance and dimensional spatial orientation . Before fitting the reflectance of finite strain ellipse oval rock that is seen as a two-dimensional strain, as determined by statistical methods which have been before the data fit only for the three sections of the strain ellipsoid is excessive, and therefore can not to avoid errors, resulting in three elliptical cross-section does not pass through the same strain ellipsoid situation. In order to obtai)

本代码是基于MATLAB开发的，主要用于仿真基于QPSK调制的OFDM信号。(OFDM QPSK)

高斯光束在传播过程中，焦点处的三维光强分布(3D intensity distribution)

OFDM系统中的资源调度算法，轮训算法与最大信干比算法(the resource scheduling algorithms of OFDM system)

图像处理中数字识别的相关算法，自己私藏的统计识别模板。神经网络/聚类分析。matlab实现。(AI-NN-PR pattern recognition matlab)

构建混沌神经网络进行负荷预测，输出负荷预测值及其与实测值的误差(Chaotic neural network)