PVmodule

通信系统仿真用到的源码，关于matlab 的，希望对大家有用 (Source code used in communication system simulation on matlab, and I hope for all of us)

著名混沌研究人员许小可的mex的matlab程序，很有参考价值(Hsu Hsiao Ke-known researchers in the chaos of the matlab mex procedure was useful)

说明：  核主元分析是一种常见的数据分析方式,常用于高维数据的降维,可用于提取数据的低维特性。(Kernel principal component analysis is a common way of data analysis, which is often used to reduce the dimension of high-dimensional data and extract the low-dimensional characteristics of data.)

Average based noise estimation

pso算法，比较好的算法，简单，可以用于多目标优化(pso algorithm, a better algorithm, simple and can be used for multi-objective optimization)

Antenna near conducting cylinder-Analytic and Numeric(FDTD)

系统仿真DCA恒定Tx在JOINT系统中(DCA constant Tx system simulation system in the JOINT)

利用Matlab生成GPS C/A 码的基带信号。 （1）产生卫星PRN 号码为“5”的一组C/A 码； （2）循环生成25 页的导航数据，GPS 时间可填入一固定的已知数值； （3）生成C/A 码扩频信号，每个C/A 码码片给出4 个采样数据； （4）基带信号采用方波信号，电平为0 和1，占空比为50 ％，不加入噪声，进一步生成某个特定的中频信号。(Matlab generated using GPS C/A code base band signal. (1) generation of satellite PRN number is " 5" a set of C/A code (2) loop generates 25 of the navigation data, GPS time can fill a fixed known value (3) to generate C/A code spread spectrum signal, each C/A code chip gives the four sampling data (4) baseband signals using square wave signal, level 0 and 1, 50 duty cycle, not to join the noise generated further a specific frequency signal.)

mfcc用matlab编程实现，12阶参数(mfcc, used in matlab)

设计IIR数字陷波器，采样率为6.4kHz，陷波频率点为50Hz、150Hz、250Hz；c1.mat为输入数据文件；并且包括陷波前后的频谱分析。(Design of IIR digital notch filter, sampling rate of 6.4kHz, notch frequency point of 50Hz, 150Hz, 250Hz c1.mat for input data files and includes the notch before and after the spectrum analysis.)