-
SI_Prova_ClaudioPereira
sistemas web,baseado em c# aspnet
- 2014-01-31 12:09:24下载
- 积分:1
-
MPC837xE-RDB_init.cfg.tar
which will use for MPC837XERDB when programming
- 2011-11-01 21:54:43下载
- 积分:1
-
Infi-90_Block_Read
Infi-90读写测试,在安装有COPOSER的计算机上可以运行,采集ABB DCS的控制逻辑块上的数据。(Infi- 90, speaking, reading and writing test, the installation of COPOSER can run on a computer, the data on the acquisition of ABB DCS control logic block.)
- 2015-01-06 11:17:43下载
- 积分:1
-
bellman_for.zip
无线传感器网络中发现从权有向图的定顶点的最短路径发现从权有向图的定顶点的最短路径( finds shortest paths a given vertex of a weighted directed graph)
- 2015-04-16 09:03:14下载
- 积分:1
-
845q
说明: 本资源,本人没有测试过,都是从网上下载下来的,你可以亲自测试。(The resources, I have not tested, are downloaded from the Internet, you can personally test.)
- 2011-03-19 00:31:31下载
- 积分:1
-
newdate
1.显示当前系统的时间。
2.网站计数器,要刷新就可以看到效果。(1 shows the current system time. 2 sites counter, to refresh you can see the effect.)
- 2011-10-16 22:53:51下载
- 积分:1
-
2downbank0120EmpireCMS
说明: 在建国60周年举国欢庆的日子里,帝国迎来了高性能、高容量的v6.0版网站内容管理系统正式版隆重发布!作为web内容管理解决方案的提供商(The country to celebrate the 60th anniversary of the day, the Empire ushered in a high-performance, high-capacity version of Web Content Management System v6.0 full version grand release! As a web content management solutions provider)
- 2011-03-22 19:28:49下载
- 积分:1
-
PWM
NXP LPC11u24 cortex-M0 PWM 示例程序(NXP LPC11u24 cortex-M0 PWM sample programs)
- 2014-02-11 10:27:56下载
- 积分:1
-
temperature-display
51单片机温度采集与显示设计 - 通过DS18B20温度传感器获取温度,并通过数码管显示,并实现了温度可手动校准(51 single-chip temperature acquisition and display design- through DS18B20 temperature sensor for temperature, and through the digital display, and achieve a temperature can be manually calibrated)
- 2013-10-13 16:26:42下载
- 积分:1
-
M8_2400
ATMEGA8_ LTC2400 6位半表头程序
LTC2400最高测量电压为5.3V,超过5.3V或反接都会烧掉。
模拟部分供电最好经过7815稳压,最高输入电压不宜超过18V。
模拟电路与数字电路分开供电。
不要使用开关电源或PWM升压、降压电路供电
(ATMEGA8_ LTC2400 6 ½ -digit meter program LTC2400 highest measured voltage is 5.3V, 5.3V or reverse will be burned over. After 7815 some of the best analog power supply voltage, the maximum input voltage should not exceed 18V. Separate analog and digital circuit power supply. Do not use a switching power supply or PWM buck, boost circuitry)
- 2021-02-08 15:19:54下载
- 积分:1