DCT_embed-and-DCT_recover

使用Matlab仿真QAM和M=4的PSK(Matlab simulation using QAM and M = 4 of the PSK)

a file to implement dsk source codes through matlab and c

均匀线阵方向图形成，包含没有波束指向和30°波束指向，加切比雪夫权值（旁瓣幅度相同）(Uniform linear array pattern formation, with no beam pointing and 30 ° beam pointing, Gache Chebyshev weights (the same side-lobe amplitude))

本程序模拟了火星、金星、水星等行星相对地球的运动轨迹，对于研究行星运动规律极有帮助。(This procedure simulated Mars, Venus, Mercury and other planets relative to Earth' s trajectory for the study of the law of planetary motion very helpful.)

modified NSGA-II algorithm

通过比较传统仅移相的波束与移相+理想延时的波束，来说明述S波段宽带阵列孔径渡越现象(To demonstrate the aperture effct of S_band windband array, this programe comparing the beam pattern of the traditional beamforming method "phase shifting only" with that of "phase shifting+ ideal delay".)

根据条形光波导折射率数据，分别针对宽高比a:b为1:1与 2:1两种情形，设计分析 ： 1. 满足单模与双模传输的 波导尺寸范围。（需要 给出色散曲线） 2. 针对两种情形，选取你 认为最佳的波导尺寸， 计算对应的模折射率。 （计算时假设上、下包 层均很厚）(According to the refractive index of the optical waveguide stripe of data, respectively, for an aspect ratio of a: b is 1: 1 and 2: 1 both cases, the design and analysis: 1. Meet single-mode and dual-mode transmission Bird size range. (need Given dispersion curve) 2. For both cases, you select That the best of the waveguide dimensions, Computes the corresponding mode refractive index. (Calculations assume that when the upper and lower package Layers are very thick))

《MATLAB时尚百例实例》实例70-83()

High Gain Microstrip Patch Antenna presentation

MIT-BIH CUDB 详细心电信号，可用于分类VT/VF 与 NSR(MIT-BIH CUDB detailed ECG can be used to classify VT/VF and NSR)