matlab

采用MATLAB中的函数filter2对受噪声干扰的图像进行均值滤波 P0308：图像的自适应魏纳滤波(MATLAB using the function affected by noise interference filter2 images mean filter P0308: Image Adaptive Weiner Filter)

仿真程序：首先需要用一个随机发生器产生（0.1）内的均匀随机数，然后再将该序列映射到对应的幅度电平｛Am｝。然后将这个范围再分成4个相等的区间，这些子区间分别对应于4个信号比特的符号00，01，10，11。检测器观察到r=Am+n，并且计算r和4种可能传输的信号幅度之间的距离，它的输出Bm就是相应于最小距离的信号电平。Bm与真正的的传输信号幅度比较，差错计数器用来对检测器产生的差错计数。(Simulation program: first need to use a random generator (0.1) the uniform random number, then the sequence is mapped to the corresponding amplitude level {Am}. Then this range has been divided into four equal intervals, these sub-intervals corresponding to four signal bits of the symbol 00,01,10,11. Detector observed r = Am+ n, and calculate r and 4 possible transmission distance between the signal amplitude, its output corresponding to the minimum distance Bm is the signal level. Bm and the real rate of transmission of the signal comparison, error detection counter is used to generate the error count.)

用MATLAB仿真DTMF,分为生成和检测两个部分(use MATLAB to simulate the DTMF including generation and detection)

descibes a simple wing design

JPEG编码程序（MATLAB） 参考一下吧 (JPEG coding procedures (MATLAB) make reference to it)

原版Leach协议的matlab实现，注释清晰，原版可用(Matlab original Leach protocol implementations, comments clear, original available)

this file is about communication simulation modeling total form of communication system in a form of mathlab modeling

本文是music算法的一种改进，其具有更好的性能，以及能够满足大多数用户的需求，希望会给大家带来方便(This article is a modified music algorithm, which has better performance, and the ability to meet the needs of most users, I hope we will bring convenience)

OFDM/OQAM调制解调源码，另外增加了上变频部分，中心频率30KHz(OFDM/OQAM modulation and demodulation ，also include up frequency to 30Khz)

在matlab或者PSCAD中对桥差不平衡电流进行仿真计算，得到仿真结果与常规计算结果一致，此方法修改简单快捷。(In matlab or PSCAD to bridge the difference between the current imbalance in the simulation calculation, the simulation results are consistent with conventional calculations, this method is simple and quick modification.)