ppln-matlab

三相逆变桥【做的有点渣，请见谅【二十字二十字二十字二十字(Three-phase inverter bridge)

说明：  用于数字控制系统，采样根轨迹法分析，设计离散控制器(For digital control systems, sampling root locus analysis, design discrete controller)

Manchester encoder for matlab

matlab antenna impedance sine integral cos integral elliot

用于指导SIMULINK环境下的电力系统仿真！(guiding for Power System Simulation under SIMULINK environment!)

适合初学者关于单机动目标CA,CV,Singer模型对比追踪效果，并配有讲解(For beginners, CA, CV and Singer models for single maneuvering target are compared and explained.)

Summary: The MPEG converter takes a MATLAB movie matrix and writes the movie to disk as an MPEG file. MATLAB Release: R12 Description: MPEG is an ISO standard movie encoding format. The MPEG converter for MATLAB takes a MATLAB movie matrix and writes the movie to disk as an MPEG file with file extension .mpg (MPGWRITE). It also takes an MPEG file and converts it into a MATLAB movie matrix (MPGREAD). (Summary: The MPEG converter takes a MATLAB movie matrix and writes the movie to disk as an MPEG file. MATLAB Release: R12 Description: MPEG is an ISO standard movie encoding format. The MPEG converter for MATLAB takes a MATLAB movie matrix and writes the movie to disk as an MPEG file with file extension. mpg (MPGWRITE). It also takes an MPEG file and converts it into a MATLAB movie matrix (MPGREAD).)

The overall objective for LTE is to provide an extremely high performance radio-access technology that offers full vehicular speed mobility and that can readily coexist with HSPA and earlier networks. OFDM/OFDMA technology is introduced for the LTE downlink, supporting very high data rates of up to 300Mbps while Single-Carrier FDMA (SC-FDMA) is used in the uplink with data rates of 80Mbps possible. Additionally, LTE supports operation both in paired and unpaired spectrum (FDD and TDD) using channel bandwidths of approximately 1.4MHz up to 20MHz. The frequency domain scheduling can be done in OFDMA. One of the main challenges in OFDMA is the high peak-to-average radio of the transmitted signal, which requires linearity in the transmitter. The linear amplifiers have low efficiency therefore, OFDMA is not an optimized solution for a mobile uplink where the

单相逆变器的matlab仿真，有效值控制及波形控制(Individual inverter matlab simulation, adjustment and RMS waveform control)

潮流计算是电力学名词，指在给定电力系统网络拓扑、元件参数和发电、负荷参量条件下，计算有功功率、无功功率及电压在电力网中的分布。潮流计算是根据给定的电网结构、参数和发电机、负荷等元件的运行条件，确定电力系统各部分稳态运行状态参数的计算。通常给定的运行条件有系统中各电源和负荷点的功率、枢纽点电压、平衡点的电压和相位角。待求的运行状态参量包括电网各母线节点的电压幅值和相角，以及各支路的功率分布、网络的功率损耗等。(Power flow calculation is a term of power science. It refers to the calculation of the distribution of active power, reactive power and voltage in power network under given network topology, component parameters and generation and load parameters. Power flow calculation is based on the given grid structure, parameters and operation conditions of generator, load and other components to determine the steady-state operation parameters of each part of the power system. Usually, the given operating conditions include the power of each power source and load point, junction voltage, balance point voltage and phase angle. The parameters to be determined include the voltage amplitude and phase angle of each bus node, the power distribution of each branch and the power loss of the network.)