gabor

Extract Edge Features using these operators

本代码包括经典的MMSE方法和LCMV方法的推导，并包括两种方法的仿真,很有用！(The code includes the derivation of the classical methods and LCMV MMSE method, and includes simulation of the two methods, very useful!)

虚拟力的无线传感网络覆盖，数据包传送源码程序，加入重复控制。( Virtual power wireless sensor network coverage, Data packet transfer source program, Join repetitive control.)

语音信号的plosa模型，matlab源代码(The voice signal plosa model, matlab source code)

This is amatlab code fo compression with psychoacoustique

Welch法谱估计和参数模型谱估计的MATLAB分析(Welch spectral estimation MATLAB analysis and parameter estimation of the model spectrum)

说明：  通过动态系统仿真，给出了上述各种MIMO体系下的仿真结果,优秀学位论文 ( Under conditions of the Proportional Fair scheduling algorithm, the above-mentioned various MIMO modes are simulated in the proposed dynamic simulation platform. A series of system level metrics are considered in the simulation.)

基于拉格朗日多项式差值，已知一些给定的数值点（xi，yi）求未知的数xt对应的yt的值。(Lagrange polynomial based on the difference between the known value of some given point (xi, yi) find the value of an unknown number of xt corresponding yt.)

双电机伺服系统的滑模控制，运行 jieh 可以看到与PID相比的控制效果，运行需要一点时间，2分钟左右，请耐心等待。(Sliding Mode Control of dual-motor servo system)

几种变化检测算法的简单演示，包括比值法，归一化法，相关系数法三种方法(Several simple demonstration of the change detection algorithm, including ratio method, normalization method, three methods of correlation coefficient)