-
niudun
牛顿下山算法 牛顿迭代算法 和牛顿差值多项式 (Newton downhill method the difference between Newton and Newton polynomial algorithm)
- 2011-05-14 18:52:04下载
- 积分:1
-
Lifurong_zhanbo
经典的buck电路的matlab仿真,可以修改自己电路中的电感电容等参数直接应用到自己电路的仿真中。(This is a buck cuicrt simulation,and you can set your L C R in this curcit.)
- 2011-10-13 16:40:58下载
- 积分:1
-
exam5_2
圆形垂直载荷作用下的弹性半空间的matlab有限元计算源程序,配套书籍是《ansys分析与matlab编程:徐荣桥》(Matlab finite element calculation of the elastic half-space under the circular vertical loads source, supporting books ansys analysis and the matlab programming: Xu Rong Bridge " )
- 2013-05-14 23:42:29下载
- 积分:1
-
Matlabfeixianxing
以Logistic曲线为例,利用Matlab编程计算非线性回归模型(To Logistic curves were calculated using Matlab programming linear regression model)
- 2010-06-08 10:13:08下载
- 积分:1
-
zkjflyjd
距离保护傅里叶模型算法
使用图基滤波器
控制阻抗轨迹显示范围
在阻抗平面画出阻抗圆特性、整定阻抗直线特性和短路阻抗轨迹( Distance protection algorithm using the Fourier model-based filter control chart shows the range impedance locus in the impedance circle characteristic impedance plane plot, setting characteristics and short-circuit impedance line impedance locus)
- 2011-01-26 19:43:57下载
- 积分:1
-
code
通过MATLAB平台对通信仿真,研究讨论Turbo码的编译码结构,四种Turbo码译码算法,讨论Turbo码中几种常见的交织器,利用MATLAB软件平台进行并行级联Turbo卷积码的性能仿真,仿真评估了不同设计参数对Turbo码性能的影响。(Through MATLAB simulation platform for communications, research and discussion Turbo code decoding structure, four kinds of Turbo code decoding algorithm, discuss several common Turbo code interleaver, using MATLAB software platform for parallel concatenated convolutional codes Turbo Performance Simulation , simulation and evaluation of different design parameters on Turbo code performance.)
- 2013-10-08 09:45:50下载
- 积分:1
-
kmeans
用matlab写的一个k-means聚类程序,简单实用(Using matlab to write a k-means clustering procedure, simple and practical)
- 2012-01-10 23:54:39下载
- 积分:1
-
Desktop
圆环阵的天线方向图 与基于SMI算法的线阵的自适应波束形成(Adaptive beamforming circular array antenna pattern SMI algorithm based linear array)
- 2014-02-18 18:21:36下载
- 积分:1
-
sy2
(1) 分别采集一段浊音和清音语音信号(是你自己说的),采样率为8KHZ,量化精度为16比特线性码;
(2) 分析帧长取为30ms(或10ms~50ms);
(3) 根据语音信号倒谱分析和LPC谱分析的编程流程图(图2.1、图2.2)编制浊音语音信号谱分析的matlab程序,上机调试给出相应波形,并根据图形,观察共振峰情况;
(4) 将语音信号换为清音语音,运行程序,与浊音语音的运行结果进行比较,并得出结论。
(5) 在LPC谱分析中,改变阶数p (p分别等于4、8、12、40)时,观察对谱包络的影响,并与信号谱(DFT谱)进行比较。
( voice signal processing)
- 2020-11-17 16:59:41下载
- 积分:1
-
PCB_FDTD
Pcb programing in matlab
- 2010-10-19 00:43:50下载
- 积分:1