Matlab-Spectrum-analysis

IS95 前向物理链路的系统仿真程序(IS95)

AHP层次分析算法的MATLAB源文件。包括三个部分，一个主函数脚本文件，输入判断矩阵，两个函数文件分别实现求最大特征根、特征向量及一致性检验。(AHP AHP algorithm MATLAB source file. Consists of three parts, a main function of the script file, enter judgment matrix, two function files are seeking to achieve maximum eigenvalue eigenvector and consistency checking.)

微分方程网格生成 计算传热学 离散方法 自适应网格(The differential equation of grid generation)

本文档是本人的自适应控制大作业，作业里分模型参考自适应控制（用smulink仿真）和CARMA模型的最小方差自适应控制，文中有详细的smulink框图和matlab程序，格式美观，分析透彻，图形整齐，对学习自适应控制的朋友有很大的帮助，谨以本人微薄的力量和成果与大家共鸣，(This document is my adaptive control large operations, operating in sub-model reference adaptive control (with smulink simulation) and the CARMA model of minimum variance adaptive control, the text has a detailed diagram smulink and matlab procedures, aesthetic format, analysis and thorough , graphics, neat, in learning adaptive control of a friend has a great help, I would like my meager results of the strength and resonance with the U.S.,)

杨氏双缝干涉 两相干光源到接收屏上P点距离r1=(D2+(y-a/2)2)1/2, r2=(D2+(y+a/2)2)1/2, 满足相干条件的光波叠加后，对于观察屏上某一确定点，即r1、r2确定后，叠加后的光强为 式中λ为光波的波长， 、 ，令相位差φ=2π（r2-r1）/λ, 最后可得公式如下： ， 最后光强I=4I0cos2（Φ/2）。 观察相干光叠加后光强的分布. (Young' s double slit interference two coherent light source to the point P on the receiving screen distance r1 = (D2+ (YA/2) 2) 1/2, r2 = (D2+ (y+a/2) 2) 1/2, meet coherent conditions lightwave after superposition, for a determined point on the viewing screen, i.e. R1, R2 is determined, the superimposed light intensity where λ is the wavelength of light, make the phase difference φ = 2π (R2-R1)/λ, final can be obtained using the following formula: Finally, the light intensity I = 4I0cos2 (φ/2). Observed coherent superposition of light intensity distribution.)

一种利用光流法检测运动物体的程序，供初学者参考。(Optical flow method by means of a moving object detection procedures for advanced users.)

this document describe the development of design of camera lens.

NN with external data

通过matlab编程 进行GPS单点定位进行测速来反映所测地点晃动情况，采样数据1s（1Hz） loadobsrinex.m 为接收机即所用GPS得到的监测数据，loadrinexGpsn.m GPS星历数据，single_v_main1.m是主程序，还有其他消除误差程序。(Through matlab programming for GPS single point positioning speed to reflect the test place moving situation, and the sampling data 1 s (1 hz) Loadobsrinex. M for monitoring data, used the GPS receiver got loadrinexGpsn. M GPS ephemeris data, single_v_main1. M is the main program, and other procedures to eliminate error. )

在matlab 下的自适应中值滤波。可以处理彩色图像( matlab colorpicture zhongzhilvbo)