hgfx1

用matlab编写的递推的极大似然辨识程序(err)

fpt.m -- Fast Poisson transform.(fpt.m-- Fast Poisson transform.)

在MATLAB中写M文件：要求用三重循环求两矩阵相乘(M file in MATLAB, write: Request to use triple-loop order to multiply two matrices)

Feeding antennas with proper signals can be difficult. The signal is often described as a voltage, and voltages are not well defined in electromagnetic wave formulations. There are several tricks to model voltage generators in such situations, and one is the magnetic frill. This model shows the basic steps of defining a magnetic frill voltage generator for a dipole antenna, and it also compares the resulting antenna impedance with known results.

一个用MATLAB编写的优化控制工具箱，非常实用(a prepared using MATLAB Toolbox optimal control, very practical)

建立matlab与kingview之间的dde连接(Finsh the DDE connection between matlab and kingview)

通信原理基于MATLAB的计算机仿真，课本上的源代码(Communication Theory MATLAB-based computer simulation, source code on the textbook)

阻塞矩阵多频信号主瓣干扰抑制-画自适应波束形成图f=6、7、8、9MHz,目标角度10，干扰11，20，-20强度分别为20db，40db，20db，20db-(Blocking matrix multi-frequency signal main lobe interference suppression- painting adaptive beamforming Figure f = 6, 7, 8, 9 MHz, target angle, interference 11,20,-20 strength to 20db, 40db, 20db, 20db-)

主要用于建模校正集和预测集样品的选择。近红外光谱模型(Mainly used for modeling calibration set and prediction set of samples to choose from.)

非常好的差分进化matlab程序，包括源代码和例子，可用于优化计算，多目标规划等方面(Matlab differential evolution very good procedures, including source code and examples, can be used to optimize the calculation, multi-objective planning)