登录
首页 » matlab » adaptive-lms

adaptive-lms

于 2013-03-20 发布 文件大小:1KB
0 260
下载积分: 1 下载次数: 7

代码说明:

  有源自适应噪声的最常用算法,该算法是基于滤波器的输出信号与期望响应之间的误差的均方值为最小。(Active adaptive noise most commonly used algorithm, which is based on the error between the filter output signal and the desired response minimum mean-square value.)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • lab7
    test music program of piano
    2010-03-13 23:40:33下载
    积分:1
  • Image-Denoising
    基于matlab编写的图像滤波程序,包括均值滤波和中值滤波,并给出了处理后的图像(Image matlab image-based filtering process, including mean filter and median filter, and gives the treatment)
    2013-04-27 14:57:08下载
    积分:1
  • shuangxianxing
    双线性变换法设计Butterworth滤波器。分别画出滤波前和滤波后的时域图和频谱图。(Bilinear transform design Butterworth filter. Draw the pre-filter and the filtered time-domain and frequency spectrum.)
    2013-12-20 16:51:54下载
    积分:1
  • ReliabilityWeib
    基于蒙特卡罗法的复杂系统可靠性仿真威布尔分布(based on the Monte Carlo simulation of complex systems reliability Weibull distribution)
    2007-07-04 09:22:58下载
    积分:1
  • dip10
    this is a digital image processing project of image segmentation in matlab with .m code files
    2011-05-27 17:51:05下载
    积分:1
  • Compar_Three_FLC
    Compare of 03 mppt fuzzy logic controllers
    2013-04-09 20:14:18下载
    积分:1
  • TD
    说明:  韩京清老师提出的微分跟踪器离散形式,采用simulink中S-function实现的程序(Han Jingqing teacher proposed differential tracker, using matlab simulink realization of the program in)
    2014-07-13 11:33:04下载
    积分:1
  • matlab
    matlab遗传算法,matlab遗传算法程序,45666011matlab遗传算法程序(matlab genetic algorithm, matlab genetic algorithm program, 45666011matlab genetic algorithm program)
    2009-11-24 11:29:28下载
    积分:1
  • Sine-wave
    单一频率的正弦相关法动态测试系统的测试方法简单,不需要对系统进行辨识。只需要观察被测系统输出信号的相差和幅值变化。通过扫频的方法测量在不同的频率点下的幅值和相位变化。在工程应用中,只需要知道被测系统的相位变化在正常的范围内就可以视系统的动态性能正常。该仿真算法只是建立了一个模型。在实际运用时还需要变换测试信号的频率和周期。(A single frequency sinusoidal correlation method of testing dynamic testing system is simple, does not require system identification. Only need to observe the difference between the measured system output signal and amplitude change. Swept through the method of measurement points at different frequencies under the amplitude and phase changes. In engineering applications, only need to know the system under test changes in the normal phase it may be possible within the framework of the dynamic performance of the system to normal. The simulation algorithm is the establishment of a model. In the practical application of test signals also needed to change the frequency and periodicity.)
    2009-11-28 14:29:19下载
    积分:1
  • GNSSMultistationPositionSystemPerformanceSimulatio
    利用GNSS实现在多参考站条件下定位的仿真程序。(Using GNSS reference station to achieve under the conditions in a multi-location simulation program.)
    2010-12-28 10:28:13下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载