GeneticAlgorithm

很好的灰度分布直方图MATLAB仿真图形，大家可以(Good gray-scale distribution histogram MATLAB simulation graphics, we can)

非常不错的书籍，《微粒群算法》供8章和2个附录，依次上传第4章绪论(Very good books, Particle Swarm Optimization for 8 chapters and two appendices, followed by From Chapter 4 Introduction)

針對單輸入與雙輸入模糊溫度控制系統，以C語言程式分別實現(For single-input and two-input fuzzy temperature control system to realize, respectively, C language programs)

用节点导纳矩阵计算三相短路电流。输入数据-形成节点阻抗矩阵-选择故障点-计算短路电流-计算个节点电压-计算指定支路的电流(this procedure is used node admittance matrix calculation of three-phase short-circuit current input data-- forming node impedance matrix-- election Optional fault-calculation of short-circuit current-voltage computing nodes designated calculated slip road-- Electricity)

3个matlab原程序文件，包括： 1-32是：图形应用篇 33-66是：界面设计篇 67-84是：图形处理篇 85-100是：数值分析篇 (three Matlab original files, including : 1-32 : Graphics Applications articles 33-66 is : interface design articles 67-84 is : graphics processing Chapter 85-100 is : Numerical Analysis Section)

该matlab程序是IEEE 802.11b的物理层仿真程序，仿真了1Mbps下DBPSK调制方式的BER(this is a matlab programme which simulat the ber of IEEE 802.11b with DBPSK in 1Mbps.)

simulink下的理想模型,采用矢量控制方案,在它的基础上可加入实际干扰因素,进一步设计控制器.(simulink under the ideal model, the use of vector control programs, based on its actual interference factors can be added to further the design of the controller.)

低频信号先进行放大，再调制解调，设计发射机和接收机(Low-frequency signal is first amplified, and then modulation and demodulation, the transmitter and receiver design)

cstr状态反馈预测控制模型 matlab中S函数建立(cstr state feedback model predictive control matlab function in the establishment of S)

求解瞬时频率函数，一般在matlab时频分析中使用(Solve the instantaneous frequency function, usually in the time-frequency analysis using matlab)