1

stm32发spwm波 oled显示 ADC采集(Stm32 send spwm wave oled display ADC acquisition)

这是一个用51单片机系统仿真ucosii工作的protues电路 本系统包括扩展64k RAM的单片机系统和杨屹移植到51单片机的ucosii 系统 使用方法： 1.安装Protues7.4版，然后用protues打开protues 8051 simulation 文件夹 中的extern ram.DSN 文件 2.打开extern ram.DSN 后，双击单片机在弹出的窗口中的Program File 选项 中选择yy.hex文件。 (yy.hex其实就是yy文件夹中keil文档编译出来的hex文 件，yy文件夹是杨屹的ucos51 系统，用keil 2 可以打开) 3.在Clock Frequency选项中输入22.184M(杨屹的ucos51 用的是22.184M hz的单片机频率) 4.双击VTERM串口调试显示屏，在Baud Rate 选项中选择19200的波特率 5.保存，点击运行就可以看到经典的hello world 了。 (1. Protues7.4 version installed, and then open the protues folder protues 8051 simulation The extern ram.DSN file 2. Open extern ram.DSN, double-click the pop-up window of SCM in the Program File option, select yy.hex file. (yy.hex actually yy folder keil out of the document compiled hex files, yy folder is Yang Yi s ucos51 system, using keil 2 Can open) 3. In the Clock Frequency option to enter 22.184M (Yang Yi of the ucos51 using a microcontroller 22.184M hz frequency) 4. Double-click VTERM serial debug display, in the Baud Rate select 19200 baud rate options 5. Save, click Run you can see the classic hello world)

液晶显示屏OCMG源程序代码，采用的方式为串口驱动。(LCD OCMG source code, the approach for the serial port driver.)

Keil 8.08 +Proteus 7.1SP2 加联调补丁，没有单片机开发板的XDJM可以用用，练练手(Keil 8.08+ Proteus 7.1SP2 FBI patch increases, there is no single-chip development board can be used with the XDJM,练练hand)

ads1.6源码 can bus总线接受端源码包(ads1.6 source can bus bus receiving end source package)

基于单片机AT89C51的直流电机控制器(AT89C51 microcontroller based DC motor controller)

DM430-L型最小系统板4位独立按键测试程序 按不同的按键，显示不同的LED灯(DM430-L minimum the system board four independent key test procedures )

two crc16 functions, one optimized for size, one optimized for speed, useful for 8-bit microprocessor

AVR,JTAG仿真软件，内涵源程序和电路图，直接烧写进单片机就可以在线仿真的(AVR, the simulation software of JTAG, content of the source code and circuit diagram, directly burned into the microcontroller can online simulation )

实时时钟（数码管）,可实现数码管闪烁效果。带闹钟功能。 proteus仿真(Reail Time Reail Time Reail Time Reail Time)