angl

对HARQ系统的吞吐量分析，主要为数据分析和统计，小波包分析提取振动信号中的特征频率。( HARQ throughput analysis of the system, Mainly for data analysis and statistics, Wavelet packet analysis to extract vibration signal characteristic frequency.)

典型的多目标粒子群算法（CMOPSO)，附测试函数,注解详细，适合学习参考(A typical multi-objective particle swarm optimization (CMOPSO), attached to the test function, annotation detailed reference for learning)

维基尼亚密码的matlab程序，解压m文件放在matlab工程目录即可！(matlab code for vigenere cipher)

alternator matlab file very good

comprision codec FOR huffman in matlab

在1x1的单位矩形中随机部署传感器节点，而且假设每个节点的通信半径一样，要求利用蒙特卡洛算法进行1000次试验分别模拟出连通率随节点数增加以及通信半径增加的变化趋势。(Random units deployed in 1x1 rectangular sensor nodes, and assumed that the communication radius of each node, requires the use of Monte Carlo algorithm to simulate the 1000 trials were increased with the number of nodes increased connectivity and communication radius increasing trends.)

digital modulation of the bit sequence, frequency modulation, amplitude modulation, phase shift keying, frequency shift keying

matlab nrs程序，含泪共享，需要的下载吧(matlab nrs procedures, sharing tears, need to download it)

线性系统频域理论的实现 包括多项式，多项式矩阵，系统的矩阵分式描述，多项式矩阵描述，系统实现等。 其中多项式描述尚未完善。(frequency domain linear systems theory, including the realization of polynomials, polynomial matrix, the matrix fraction description, polynomial matrix description of system implementation. Description polynomial which is not yet perfect.)

说明：  The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):