登录
首页 » matlab » DTC_six

DTC_six

于 2021-04-20 发布 文件大小:15KB
0 274
下载积分: 1 下载次数: 102

代码说明:

  基于matlab/simulink的异步电机直接转矩控制,仿真运行正常。(Based on matlab/simulink asynchronous motor direct torque control, simulation run correctly.)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 06dtvtsimulationplatformsforofdm
    SIMULATION BY MATLA INCLUDE OFDM
    2010-12-08 10:36:27下载
    积分:1
  • td1
    tdoa. wsn. time difference of arrival simulation.
    2013-11-08 15:31:34下载
    积分:1
  • RLDA_Train
    Regularized Linear Discriminant analysis. EEG signal
    2014-12-14 14:49:10下载
    积分:1
  • ParametricBezier
    a code bezier parameters
    2014-12-15 21:12:29下载
    积分:1
  • tamrin-seri-2
    matlab program for adapting filter
    2014-01-29 19:27:24下载
    积分:1
  • Equal-area-azimuthal-projection
    Equal area azimuthal projection
    2015-01-13 15:32:27下载
    积分:1
  • Self_Taught_Learning
    该文档包含了深度学习中语言自学习示例,包括详细的程序和代码(this document contain Self Taught Learning of deep learning)
    2015-03-28 20:35:16下载
    积分:1
  • pinpu
    信号的频率选择性衰落,根据频率的不同,在某些点上信号增强,某些点上信号减弱,此代码为MATLAB建模的仿真代码,开发环境为matlabR2011B(The signal frequency selective fading)
    2014-03-24 23:07:36下载
    积分:1
  • OFDM-basedWirelessBroadBandSystemSimulator
    基于OFDM的无线宽带系统仿真It contains mainly two parts, i.e. link-level simulator and system-level simulator. Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx. Comparing the difference in tx/rx signal, the error rate can be found out. The output of the link-level simulator is the BLER/BER vs. SNR mapping table, that can be used for the system-level simulation. System-level simulator focus on a multi-cell multi-user scenario. For the sake of simplicity, it takes the mapping table aquired in the link-level simulation, measure the actural SNR, and finds the corresponding error rate.(OFDM-based wireless broadband system simulation It contains mainly two parts, ie link-level simulator and system-level simulator.Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx . Comparing the difference in tx/rx signal, the error rate can be found out. The output of the link-level simulator is the BLER/BER vs. SNR mapping table, that can be used for the system-level simulation.System- level simulator focus on a multi-cell multi-user scenario. For the sake of simplicity, it takes the mapping table aquired in the link-level simulation, measure the actural SNR, and finds the corresponding error rate.)
    2008-01-05 00:08:29下载
    积分:1
  • Numerical_Analysis_with_MATLAB
    It provides some examples in numerical analysis using Matlab like solving polinomies, solution on nonlinear equations, etc.
    2009-12-13 23:25:52下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载