GPS_corr

emd分解中采用对称延拓消除边界效应，供大家参考学习(emd decomposition of symmetric extension used to eliminate the boundary effects)

《射频电路设计——理论与应用》一书课后习题第五章Matlab程序代码("RF circuit design-- Theory and Application," a book OSCAR Exercise fifth chapter Matlab code)

simulink transformator

该文件中包含了详细的matlab实现的源代码，很适合初学者入门。代码的运行环境有要求： 1. 软件环境 需要安装暴风影音才能正常播放.WMV文件； MATLAB R2011b 版本的软件。 2. 硬件环境 处理器：CPU主频不低于1GHz； 内存：不小于256MB； 硬盘：不小于10GB； 显示器：支持1024*768分辨率。(The file contains a detailed matlab realize the source code, it is suitable for beginners. Operating environment code required: 1 Software Environment         STORM need to be installed in order to play properly .WMV file         MATLAB R2011b version of the software.     2 hardware environment         Processor: CPU clock speed of not less than 1GHz         Memory: not less than 256MB         Hard disk: not less than 10GB         Display: 1024* 768 resolution.)

基于区域生长的彩色图像分割算法的研究与应用(Research and Application of Regional Growth Color Image Segmentation Algorithm)

数据降维工具箱，包括一些典型算法，例如pca，lle，mds，lda等。(Data dimensionality reduction tool kit, including some typical algorithms, such as the pca, lle, mds, lda, etc..)

I send matlab codin for OFDM transceiver design

说明：  在求解每日零息债券的基础之上，计算每日远期利率曲线 (basing on Solving zero-coupon bonds in the daily basis, calculated daily initial forward rate curve in future)

The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):

Interference Management with Relay Cooperation in Two-Hop Interference Channels